Influence of Cavity Length on Forward-facing Cavity and Opposing Jet Combined Thermal Protection System Cooling Efficiency
ثبت نشده
چکیده
A numerical study on the influence of forward-facing cavity length upon forward-facing cavity and opposing jet combined thermal protection system (TPS) cooling efficiency under hypersonic flow is conducted, by means of which the flow field parameters, heat flux distribution along the outer body surface are obtained. The numerical simulation results are validated by experiments and the cooling effect of the combined TPS with different cavity length is analyzed. The numerical results show that the combined configuration dose well in cooling the nose of the hypersonic vehicle. The deeper the cavity is, the weaker the heat flux is. The recirculation region plays a key role for the reduction of the aerodynamic heating. Keywords—Thermal protection, hypersonic vehicle, aerodynamic heating, forward-facing cavity, opposing jet
منابع مشابه
Numerical study of a combined convection flow in a cavity filled with nanofluid considering effects of diameter of nanoparticles and cavity inclination angles
The present paper focuses on problem of mixed convection fluid flow and heat transfer of Al2O3-water nanofluid with temperature and nanoparticles concentration dependent thermal conductivity and effective viscosity inside Lid-driven cavity having a hot rectangular obstacle. The governing equations are discretized using the finite volume method while the SIMPLER algorithm is employed to couple v...
متن کاملCompare three different algorithms (MOPSO, SPEA2, NSGA-II) for Multi Objective Optimization of a novel Combined Cooling, Heating, and Power (CCHP) system based on organic Rankine cycle
Recently Debates about Energy and the issue of global warming have led to the use of new energy. One of the best options for this purpose is the use of a new hybrid system of power, heating and refrigeration, with its thermal source of solar and geothermal energy. In the present study, used a combined cooling, heating and power system based on the organic Rankine cycle and the Ejector Refrigera...
متن کاملLEM Characterization of Synthetic Jet Actuators Driven by Piezoelectric Element: A Review
In the last decades, Synthetic jet actuators have gained much interest among the flow control techniques due to their short response time, high jet velocity and absence of traditional piping, which matches the requirements of reduced size and low weight. A synthetic jet is generated by the diaphragm oscillation (generally driven by a piezoelectric element) in a relatively small cavity, producin...
متن کاملEffect of Insulated Up and Down Lid Motion on the Heat Transfer of a Lid-Driven Cavity with an attached fin
This study investigates the effect of lid motion on the optimal characteristics a thin rectangular fin attached on the hot wall of a square lid-driven cavity with active vertical walls. The optimal fin position is studied for Richardson numbers of 0.1-10. The effect of mounting a rectangular fin with a thermal conductivity of 1 and 1000 on minimization and maximization of heat transfer through ...
متن کاملModeling of a Geothermal Cycle Condenser in a Combined Diesel Power Cycle: Case Study of 42 MW Diesel Power Plant in Moghan and Ardabil
This paper presents the results of a research into the feasibility of recovering waste heat and determining design parameters of a recovery boiler for a set of medium-speed diesel generators with a capacity of 7 MW (the nominal capacity of all units is 42 MW, which would be a study on a unit). And is used to generate electricity. The main purpose of this study is to design a thermal waste recov...
متن کامل