A Strain Gauge Torque Transducer Calibration Study

-This paper presents for the study of torque transducer (torque sensor) calibration built into a rotating shaft, in this case uses strain gauge, which was done with, and the output signal of the "voltage (mV/V)" has been taken for each weight, increasing and decreasing the weights. The data have been taken three times which they have been divided into three series. First and foremost, the average of the three series has been calculated. Next, the indicated strain value has been calculated. Then, the strain for each resistance has been also calculated in "με" at "torque (M)" = 22.0725Nm and found that equals to (33.3με). Moreover, first step testing has been calibrated without loads, the results have been measured three times to be ready for the next step. Finally, the torque transducer during operation in real condition, measurement of the mechanical power and speed will be done.