Optical Constants of Crystallized TiO2 Coatings Prepared by Sol-Gel Process
نویسندگان
چکیده
Titanium oxide coatings have been deposited by the sol-gel dip-coating method. Crystallization of titanium oxide coatings was then achieved through thermal annealing at temperatures above 400 °C. The structural properties and surface morphology of the crystallized coatings were studied by micro-Raman spectroscopy and atomic force microscopy, respectively. Characterization technique, based on least-square fitting to the measured reflectance and transmittance spectra, is used to determine the refractive indices of the crystallized TiO₂ coatings. The stability of the synthesized sol was also investigated by dynamic light scattering particle size analyzer. The influence of the thermal annealing on the optical properties was then discussed. The increase in refractive index with high temperature thermal annealing process was observed, obtaining refractive index values from 1.98 to 2.57 at He-Ne laser wavelength of 633 nm. The Raman spectroscopy and atomic force microscopy studies indicate that the index variation is due to the changes in crystalline phase, density, and morphology during thermal annealing.
منابع مشابه
Kinetics of photocatalytic degradation of methylene blue on nanostructured TiO2 coatings created by sol-gel process
Sol-gel process was chosen to produce a photocatalytic film to degrade methylene blue. In order to study structural and morphological properties of the coatings, a base sol of TTIP, I-PrOH, and DEA was prepared. Then with addition of 45g/L PEG 2000, 30g/L TiO2 and 15g/L PEG 2000 + 30g/L TiO2, to the base sol, three other sols were produced. The results of this study indica...
متن کاملInvestigation of corrosion protection properties of TiO2-CdO nanocomposite coating prepared by sol-gel method on copper
the Sol–gel nanocomposite coatings have been investigated for copper metal as a potential replacement for the hazardous and banned hexavalent chromate conversion coatings. TiO2–CdO nanocomposite thin films were deposited on copper using the sol–gel method. The sol-gel coatings were prepared using a sol obtained by the hydrolysis and condensation of tetra-o-butyl titanate. They were doped with c...
متن کاملOn the Investigation of Sol-Gel TiO2 Nanostructured Films Applied on Windshields Pre-Coated with SiO2 Layer by Dip-Coating Method
TiO2-SiO2 photocatalytic nanostructure film on windshield for self-cleaning purposes was prepared via sol–gel dip-coating method. TiO2 films were prepared on automotive glass pre-coated with a SiO2 layer by a dip-coating method followed by annealing at 500 °C for 30min. The films were characterized using X-ray diffraction XRD and scanning electron microscopy SEM, FE-SEM techniques. The TiO2-SiO...
متن کاملCharacterisation of TiO2 Thin Films and Multilayer Antireflective Coatings - SE07
TiO2 films are extensively studied because of their interesting chemical, electrical and optical properties. TiO2 is a high bandgap semiconductor that is transparent to visible light and has excellent optical transmittance. TiO2 has high refractive index and good insulating properties, and as a result it is widely used as protective layer for very large scale integrated (VLSI) circuits and for ...
متن کاملEvaluation of Photocatalytic Activity of Fe Doped TiO2 Thin Film Prepared by sol-gel hot dip-coating
The application of Fe–TiO2 photocatalysis using sol–gel method by hot–dipping technique was investigated. Then, the influences of fabrication parameters, molar ratios of Fe to TiO2, the sol temperature, poly ethylene glycol (PEG) content and the number of dipping cycles on the photocatalytic activity in visible light region were mainly studied. The experimental results revealed the sample with ...
متن کامل