The Existence of a Sticking Region in Free Weight Squats
نویسندگان
چکیده
The aim of this study was to investigate the existence of the sticking region in two legged free weight squats. Fifteen resistance-training males (age 24 ± 4 years, body mass 82 ± 11 kg, body height 179 ± 6 cm) with 6 ± 3 years of resistance-training experience performed 6-RM in free weight squats. The last repetition was analyzed for the existence of a sticking region. Only in 10 out of 15 participants a sticking region was observed. The observed sticking region was much shorter than in the bench press. Furthermore, rectus femoris decreased the EMG activity in contrast to increased EMG activity in biceps femoris around the sticking and surrounding region. No significant change in EMG activity was found for the lateral and medial vastus muscles. It is suggested that a combination of these muscle activity changes could be one of the causes of the existence of the sticking region in free weight squats.
منابع مشابه
A Comparison of Muscle Activity in Concentric and Counter Movement Maximum Bench Press
The purpose of this study was to compare the kinematics and muscle activation patterns of regular free-weight bench press (counter movement) with pure concentric lifts in the ascending phase of a successful one repetition maximum (1-RM) attempt in the bench press. Our aim was to evaluate if diminishing potentiation could be the cause of the sticking region. Since diminishing potentiation cannot...
متن کاملEffect of colloidal Particles associated with the liquid bridge in sticking during drying in Superheated Steam
It is very important in the design of a drying system is to evaluate sticking behaviour of the materials goes under drying. A new approach to the sticking issue is applied in this study by carrying out a sticking test for the liquid associated with the materials under study. It was found that the liquid bridge is responsible of the initial sticking of the materials to the contact surface and th...
متن کاملUndergraduate Research: From Discovery to Application produced with squats using conventional weights at 1Gz
produced with squats using conventional weights at 1Gz. Subjects were divided into two groups. One group performed conventional squats resistance training (SRT) using free weights while the other group performed squat hypergravity resistance training (SHRT) on the Space Cycle. Each subject exercised eight times over two weeks on either the Space Cycle or using conventional squats. To determine ...
متن کاملMathematical Modeling of the Differential Sticking Coefficient of Clay Drilling Fluids
The main objective of this work is to propose a mathematical model for the differential sticking coefficient of clayey drilling fluids with a lubricant as an additive and evaluate the influence of differential pressure and lubricant content on filter cake thickness and permeability. Tests were carried out on fluids composed of water and 4.86% of active bentonite clay prepared in Hamilton Beach ...
متن کاملDetermining the optimal load for jump squats: a review of methods and calculations.
There has been an increasing volume of research focused on the load that elicits maximum power output during jump squats. Because of a lack of standardization for data collection and analysis protocols, results of much of this research are contradictory. The purpose of this paper is to examine why differing methods of data collection and analysis can lead to conflicting results for maximum powe...
متن کامل