The Brittle-Ductile Transition in Mixtures of Rock and Ice: Experiments at Planetary Conditions
نویسندگان
چکیده
Introduction: Mars exhibits a wide variety of landforms that are indicative of ductile flow, ranging from the viscous creep of ice-rich permafrost [1] to the glaciation of thick Martian ice sheets [2] to the surface mobility of thin debris flows [3]. All of these flow features probably contain significant amounts of dust, which for example will likely be present throughout the impact-disrupted subsurface megare-golith [4], within dark bands in the Polar Layered Deposits [2], and inside sublimation lag layers atop ablating near-surface ice [5]. Due to the unknown rheological effects of dust upon water ice undergoing creep, the proportion of ice required to produce such deformation is uncertain. Mangold et al. [6] attempted to constrain the volumetric ice fraction by conducting constant load triaxial tests at differential stresses of 1.9-8.5 MPa, confining pressures of 12 MPa, and temperatures of 263 K. For ice contents ranging from 25% to 48%, they obtained relative viscosities 10-50 times higher than that of pure ice under the same conditions [6]. Moreover, Mangold et al. [6] concluded that the brittle-ductile transition in ice-rock mixtures occurs at ice fractions lower than 28%; hence, if the upper kilometer of the Martian megaregolith is comprised of ice-rich permafrost undergoing ductile deformation, then this 28% minimum value implies a global equivalent subsurface layer of at least 200 m [6]. We have recently begun an ongoing investigation into the rheology of ice-rock mixtures at planetary conditions, the main objective of which is to update the 1992 work of Dur-ham et al. [7] in order to assess the effects of particulates upon grain-size sensitive creep of water ice at low temperatures ranging from 77 K to 223 K. As part of this research program, our initial experiments on ice-rock mixtures should provide more detailed constraints on the nature of the brittle-ductile transition at low temperatures—and, by extension, the minimum ice content required for ductile flow on Mars. The Brittle-Ductile Transition: The maximum particle loading tested in our earlier 1992 work was 56% by volume [7]. At higher loading, conventional testing becomes problematic as the higher differential stresses that must be applied move the deformation regime closer to the brittle-ductile transition, a rather fundamental change in deformation mechanism, with a strong shift in the dependence of viscosity on temperature, pressure, and strain rate. The brittle-ductile transition in all rocks, including ice + rock mixtures, is gradual , with cataclastic fracturing and crushing …
منابع مشابه
Dynamic and Quasi-Static Tensile Properties of Structural S400 Steel
The study of mechanical behavior of the structural steel S400 under quasi- static and dynamic loading has been the subject of this investigation. In oder to obtain different stress - triaxiality conditions the specimens were notched with 1, 1.5, 2 and 3.5 mm notch radius. The results of fractography show as the velocity of tension increases, ductility reduces and a ductile-brittle transition oc...
متن کاملInfluence of phyllosilicates on fault strength in the brittle–ductile transition: insights from rock analogue experiments
Despite the fact that phyllosilicates are ubiquitous in mature fault and shear zones, little is known about the strength of phyllosilicate-bearing fault rocks under brittle–ductile transitional conditions where cataclasis and solution-transfer processes are active. In this study we explored steady-state strength behaviour of a simulated fault rock, consisting of muscovite and halite, using brin...
متن کاملHOT CRACK FORMATION IN PURE CU AND CU-30%ZN ALLOY DURING IN SITU SOLIDIFICATION
The hot cracking susceptibility can be determined by establishing the transition temperature between brittle and ductile fracture at high temperature tensile testing of in situ solidified samples. High temperature tensile properties were determined for commercial cathodic pure Cu and Cu- 30%Zn alloy. The transition temperatures for pure Cu and Cu-30%Zn were evaluated from ultimate tensile stres...
متن کاملDislocation mobility and crack tip plasticity at the ductile-brittle transition
Recent ideas on the mechanisms controlling the initial stages of plastic flow at cracks in intrinsically brittle materials, at the ductile-brittle transition, are reviewed. New experiments on precracked specimens of Si are reported, which confirm earlier work that the ductile-brittle transition is controlled by dislocation velocity. A model has been developed in which at the ductile-brittle tra...
متن کاملAnalyzing Surface Structures on Icy Satellites: a Physical Analogue
Introduction: The existence of global oceans on some icy satellites—Europa and Enceladus, for example—implies the presence of a ductile warm ice layer. However, the role of such a ductile layer in controlling icy-surface deformation has never been systematically investigated nor quantified. We aim to address this issue by combining previous observations from geomorphological mapping of surface ...
متن کامل