High-energy, kHz-repetition-rate, ps cryogenic Yb:YAG chirped-pulse amplifier.
نویسندگان
چکیده
We demonstrate amplification of picosecond laser pulses to 40?mJ at a 2?kHz pulse repetition frequency (PRF) from a two-stage cryogenic chirped-pulse Yb:YAG amplifier, composed of a regenerative amplifier (RGA) and a two-pass booster amplifier. The RGA produces 8.2mJ of energy at 2kHz PRF and 13.2mJ at 1kHz PRF with excellent energy stability (approximately 0.3% rms) and beam quality (M(2)<1.1). Pulse stretching and compression are achieved by using a chirped fiber Bragg grating and a multilayer dielectric grating pair, respectively. Compressed 15?ps pulses from the RGA are obtained with a throughput efficiency of approximately 80% (approximately 6.5 mJ for 2kHz). The booster amplifier further amplifies the pulses to 40mJ at 2kHz PRF, and approximately 32 mJ, approximately 15 ps pulses are expected after compression. The amplifier chain seeded from a femtosecond Yb-fiber laser enables the optical self-synchronization between signal and pump in optical parametric chirped-pulse amplifier applications.
منابع مشابه
Twenty-watt average output power, picosecond thin-rod Yb:YAG regenerative chirped pulse amplifier with 200 μJ pulse energy
A high-average power, laser-diode-pumped, picosecond-pulse regenerative chirped pulse amplifier was developed by using the thin-rod Yb:YAG laser architecture. An average output power of 20 W was achieved at a repetition rate of 100 kHz with an output pulse width of 2 ps. 2008 Optical Society of America OCIS codes: (140.3280) Lasers, amplifiers, (140.3615) Lasers, ytterbium, (140.3480) Lasers, ...
متن کاملYb:YAG Innoslab amplifier: efficient high repetition rate subpicosecond pumping system for optical parametric chirped pulse amplification.
We report on a Yb:YAG Innoslab laser amplifier system for generation of subpicsecond high energy pump pulses for optical parametric chirped pulse amplification (OPCPA) at high repetition rates. Pulse energies of up to 20 mJ (at 12.5 kHz) and repetition rates of up to 100 kHz were attained with pulse durations of 830 fs and average power in excess of 200 W. We further investigate the possibility...
متن کاملRegenerative spectral and pulse shaping of high average power chirped pulse thin-rod Yb:YAG amplifier
Spectral gain narrowing of high-average power, regenerative chirped pulse thin-rod Yb:YAG amplifier was compensated by the regenerative spectral and pulse shaping technique. An average output power of 18 W was achieved at a repetition rate of 100 kHz with an output pulse width of below 1.2 ps. A wide spectral bandwidth of 2.5 nm was also observed. 2009 Optical Society of America OCIS codes: (1...
متن کامل20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier
This is a report on a 100 W, 20 mJ, 1 ps Yb:YAG thin-disk regenerative amplifier. A homemade Yb:YAG thin-disk, Kerr-lens mode-locked oscillator with turn-key performance and microjoule-level pulse energy is used to seed the regenerative chirped-pulse amplifier. The amplifier is placed in airtight housing. It operates at room temperature and exhibits stable operation at a 5 kHz repetition rate, ...
متن کاملGeneration of 287 W, 5.5 ps pulses at 78 MHz repetition rate from a cryogenically cooled Yb:YAG amplifier seeded by a fiber chirped-pulse amplification system.
We generate linearly polarized, 287 W average-power, 5.5 ps pulses using a cryogenically cooled Yb:YAG amplifier at a repetition rate of 78 MHz. An optical-to-optical efficiency of 41% is obtained at 700 W pump power. A 6 W, 0.4 nm bandwidth picosecond seed source at 1029 nm wavelength is constructed using a chirped-pulse fiber amplification chain based on chirped volume Bragg gratings. The com...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics letters
دوره 35 11 شماره
صفحات -
تاریخ انتشار 2010