Wet oxidation of GeSi at 700 “C
نویسندگان
چکیده
About 500-nm-thick films of Ge,-,,6Sic64 and Ge o.28Si0.72 grown epitaxially on ( 100)Si have been oxidized at 700 “C in wet ambient. A uniform Ge,Sit -,O, oxide layer forms with a smooth interface between it and the unoxidized Ge$i, _ X layer below. The composition and structure of that layer remains unchanged as monitored by backscattering spectrometry or cross-sectional transmission electronic microscopy. The oxide of both samples grows as square root of oxidation duration. The parabolic rate constant increases with the Ge content and is larger than that for wet oxidation of pure Si at the same temperature. The absence of a regime of linear growth at this relatively low temperature indicates a much enhanced linear rate constant.
منابع مشابه
Importance of sample preheating in oxidation of Gesi,-,
Wet thermal oxidation at 1000 “C of a 470-nm-thick epitaxial Ge~&3,,~ layer on ( 100)Si produces oxides of different composition depending on the details of the oxidation procedure. When a cold sample is directly exposed to the hot steam, the surface layer of the oxide contains both Ge and Si. Only SiOZ forms if a preheated sample is exposed to the hot steam. The effect is not present for dry o...
متن کاملInstability of a Gesi 1 - x 02 film on a Ge & - , layer
The stability of an amorphous Ge.$i t-,0, in contact with an epitaxial (lOO)Ge,Si,-, layer obtained by partially oxidizing an epit.axial Ge,Si,-, layer on a (1OO)Si substrate in a wet ambient at 700 “C is investigated for x=0.28 and 0.36 upon annealing in vacuum at 900 “C for 3 h, aging in air at room temperature for 5 months, and immersion in water. After annealing at 900 “C!, the oxide remain...
متن کاملInvestigating the Composition and Conductance Distributions on Highly GeSi Mixed Quantum Dots and Inside Oxidation Problem.
With the help of a nanoscale trench, the composition and conductance distributions of single GeSi quantum dots (QDs) are obtained by conductive atomic force microscopy combined with selective chemical etching. However, the obtained composition and current distributions are unwonted and inconsistent on the QDs grown at 680 °C. With a series of confirmatory experiments, it is suggested that a thi...
متن کاملCo3O4 spinel protection coating for solid oxide fuel cell interconnect application
In the present study, electrophoretic deposition (EPD) method in different electric fields (30 – 300 V / cm) was used to apply Co3O4 spinel coating to SUS 430 as SOFC interconnect. The coated and uncoated specimens were pre-sintered in air at 800 and 900 °C for 3 h followed by cyclic oxidation at 700 and 800 °C for 500 h, respectively. X-ray diffraction analysis (XRD), Scanning Electron Microsc...
متن کاملInfluence of Operational Parameters and Kinetic Modelling of Catalytic Wet Air Oxidation of Phenol by Al/Zr Pillared Clay Catalyst
Single and mixed oxide Al/Zr-pillared clay (Al/Zr-PILC) catalysts were synthesized and tested for catalytic wet air oxidation (CWAO) of aqueous phenol solution under milder conditions, in a semi-batch reactor. The catalysts were synthesized from natural bentonite clay using ultrasonic treatment during the aging and intercalation steps and were characterized <...
متن کامل