Resharpening of the twist drill bits
ثبت نشده
چکیده
To get a good performance from a drill bit the sharpening must be done correctly, this means that all the angles and the lengths of the edges must be exactly as established and will not occur during the grinding edge of the material structural modifications. To execute the correct sharpening are therefore required special equipment and dedicated grinding machines. The geometric elements to consider are:
منابع مشابه
Comprehensive analysis of delamination in drilling of composite materials with various drill bits
Beside the twist drill, the effects of various drill geometries were rarely discussed in analytical fashion. This study presents a comprehensive analysis of delamination in use of various drill types, such as saw drill, candle stick drill, core drill and step drill. In this analysis, the critical thrust force at the onset of delamination is predicted and compared with the twist drill. © 2003 El...
متن کاملA Theoretical Analysis on Bone Drilling Temperature Field of Superhard Drill
To overcome strong drilling force and over high temperature during orthopedic surgery, the four medical drills with different geometrical shapes by using superhard materials were designed. The bone drilling temperature field of superhard drill was theoretical analyzed. Results showed that brazed step drill has the most ideal drilling temperature. It controls the maximum bone temperature below 4...
متن کاملSimulation-based twist drill design and geometry optimization
Designing a high-performance twist drill is difficult due to the complex relationship between drill geometry and numerous and conflicting design goals. Earlier approaches of computer-aided twist drill design are limited to only few design aspects. This article presents a new holistic method of using computing power for twist drill design and optimization. A complete drill geometry model is used...
متن کاملTaguchi analysis of delamination associated with various drill bits in drilling of composite material
This paper presents a prediction and evaluation of delamination factor in use of twist drill, candle stick drill and saw drill. The approach is based on Taguchi’s method and the analysis of variance (ANOVA). An ultrasonic C-Scan to examine the delamination of carbon fiber-reinforced plastic (CFRP) laminate is used in this paper. The experiments were conducted to study the delamination factor un...
متن کاملComputerized Tomography and C-scan for Measuring Drilling-Induced Delamination in Composite Material Using Twist Drill and Core Drill
Delamination is one of the most concern defects in drilling of composite material. Delamination depends on the factors such as feed rate, tool geometry and wear. The mechanics of drilling composite materials has been examined along with the quality of the hole and the effect of tool design parameters. The capacity of computerized tomography (CT) showing sample cross-section in a nondestructive ...
متن کامل