Measurement of sampling jitter in analog-to-digital and digital-to-analog converters using analytic signals
نویسندگان
چکیده
A method of sampling jitter measurement based on time-domain analytic signals is proposed. Computer simulations and actual measurements were performed to compare the proposed method with the conventional method, in which jitter is evaluated from the amplitudes of sideband spectra for observed signals in the frequency domain. The results show that the proposed method is effective in that it 1) provides high temporal resolution as a result of the direct derivation of the jitter waveform, 2) achieves higher accuracy in the measurement of jitter amplitude, and 3) can separate phase modulation that originate in sampling jitter from amplitude modulation that originate in digitalto-analog and analog-to-digital conversion processes. Suitable measurement conditions and measurements to separate the effects of jitter in a digital-to-analog converter and an analog-to-digital converter are described.
منابع مشابه
Improving adaptive resolution of analog to digital converters using least squares mean method
This paper presents an adaptive digital resolution improvement method for extrapolating and recursive analog-to-digital converters (ADCs). The presented adaptively enhanced ADC (AE-ADC) digitally estimates the digital equivalent of the input signal by utilizing an adaptive digital filter (ADF). The least mean squares (LMS) algorithm also determines the coefficients of the ADF block. In this sch...
متن کاملAnalysis of Integral Nonlinearity in Radix-4 Pipelined Analog-to-Digital Converters
In this paper an analytic approach to estimate the nonlinearity of radix-4 pipelined analog-to-digital converters due to the circuit non-idealities is presented. Output voltage of each stage is modeled as sum of the ideal output voltage and non-ideal output voltage (error voltage), in which non-ideal output voltage is created by capacitor mismatch, comparator offset, input offset, and finite ga...
متن کاملSampling Jitter in Audio A/D Converters
This paper provides an overview of the effects of timing jitter in audio sampling analog-to-digital converters (ADCs), i.e. PCM (conventional or Nyquist sampling) ADCs and sigma-delta (Σ∆) ADCs. Jitter in a digital audio is often defined as shortterm fluctuations of the sampling instants of a digital signal from their ideal positions in time. The influence of the jitter increases particularly w...
متن کاملPerformance Analysis Of Mono-bit Digital Instantaneous Frequency Measurement (Difm) Device
Instantaneous Frequency Measurement (IFM) devices are the essential parts of anyESM, ELINT, and RWR receiver. Analog IFMs have been used for several decades. However, thesedevices are bulky, complex and expensive. Nowadays, there is a great interest in developing a wideband, high dynamic range, and accurate Digital IFMs. One Digital IFM that has suitably reached allthese requirements is mono-bi...
متن کاملMOCA ARM: Analog Reliability Measurement based on Monte Carlo Analysis
Due to the expected increase of defects in circuits based on deep submicron technologies, reliability has become an important design criterion. Although different approaches have been developed to estimate reliability in digital circuits and some measuring concepts have been separately presented to reveal the quality of analog circuit reliability in the literature, there is a gap to estimate re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2010