Designing an Appropiate Order of Fir Filter Using Windowing Method
نویسندگان
چکیده
This paper the authors mainly concern with the best order of the FIR filter using Boxcar windowing method. Simulation results give encouraging results regarding best order of the FIR Filters among the orders. A new method of implementation of best order of FIR Filter is proposed using MATLAB SIMULINK. Interesting results are obtained by comparing the different order filter’s cut-off frequency to the assumption fixed 1000 Hz using Boxcar window. This novel concept of finding of the best order of the FIR filter using different order in Boxcar windows method that has been verified through MATLAB simulation results. KeywordsFIR, MATLAB SIMULINK, DSK5416 Kit, TMSC32054 hardware.
منابع مشابه
Design of IIR Digital Filter using Modified Chaotic Orthogonal Imperialist Competitive Algorithm (RESEARCH NOTE)
There are two types of digital filters including Infinite Impulse Response (IIR) and Finite Impulse Response (FIR). IIR filters attract more attention as they can decrease the filter order significantly compared to FIR filters. Owing to multi-modal error surface, simple powerful optimization techniques should be utilized in designing IIR digital filters to avoid local minimum. Imperialist compe...
متن کاملDesigning and Implementation of Digital Filter for Power line Interference Suppression
This paper presents removal of noise from the ECG signal by using Digital filters designed with FIR and IIR technique. The analysis of ECG signal has great importance in the detection of cardiac abnormalities. The ECG signal is preserve of the electrical performance of heart versus time. ECG signal of a normal heart beat consists of a three parts P wave, QRS complex and T wave. The P wave refle...
متن کاملOptimal fast digital error correction method of pipelined analog to digital converter with DLMS algorithm
In this paper, convergence rate of digital error correction algorithm in correction of capacitor mismatch error and finite and nonlinear gain of Op-Amp has increased significantly by the use of DLMS, an evolutionary search algorithm. To this end, a 16-bit pipelined analog to digital converter was modeled. The obtained digital model is a FIR filter with 16 adjustable weights. To adjust weights o...
متن کاملFast Design Algorithms for FIR Notch Filters
Based on symmetry of the maximally flat frequency response of a FIR notch filter the new design procedure is developed. The closed form solution provides direct computation of the frequency response, recursive computation of the impulse response coefficients, simple windowing technique, and an access to new implementation. Several examples are included. INTRODUCTION In order to remove a single ...
متن کاملInterference Mitigation of Replay Attacks in GPS Receiver using of Finite Impulse Response Filter
The vulnerability of civil GPS receiver to interference may be intentional or unintentional. Among all types of interference, replay attack intended as the most dangerous intentional one. The signal structure of replay attack is almost the same with the satellite signal. The interference effects can be reduce with the design of an appropriate filter in the receiver. This paper presents two meth...
متن کامل