Design and Control of a Hydraulic Human Power Amplifier
نویسنده
چکیده
1 2 This paper describes the design of and some preliminary control results for a hydraulically actuated human power amplifier. The system is in the form of an oar, with its reach and pitch degrees of freedom being hydraulically assisted. A robust PI force controller is proposed so that the hydraulic actuator force tracks a scaled copy of the force exerted by the human. Nonlinearities and uncertainties in the compression spring, as well as parametric uncertainties are taken into account. The passivity property of the closed loop system is also analyzed. The controller has been tested in simulations and experimentally. It is shown to be effective when pushing against an object, and in assisting in bearing static loads.
منابع مشابه
Passive Control of a Hydraulic Human Power Amplifier Using a Hydraulic Transformer
The hydraulic human power amplifier is a tool that uses hydraulic actuation to amplify the force that the human exerts on it. Our control objective and framework are to make the system behave like a passive mechanical tool when interacting with the human and with the work environment with a specified power scaling factor. A virtual velocity coordination control approach casts the human power am...
متن کاملNon-linear modeling, analysis, design and simulation of a solid state power amplifier based on GaN technology for Ku band microwave application
A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...
متن کاملA 28-36 GHz Optimized CMOS Distributed Doherty Power Amplifier with A New Wideband Power Divider Structure
Background and Objectives: In this paper, a new design strategy was proposed in order to enhance bandwidth and efficiency of power amplifier. Methods: To realize the introduced design strategy, a power amplifier was designed using TSMC CMOS 0.18um technology for operating in the Ka band, i.e. the frequency range of 26.5-40GHz. To design the power amplifier, first a power divider (PD) with a ver...
متن کاملA New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملEffective Design of a 3×4 Two Dimensional Distributed Amplifier Based on Gate Line Considerations
In this paper two dimensional wave propagation is used for power combining in drain nodes of a distributed amplifier (DA). The proposed two dimensional DA uses an electrical funnel to add the currents of drain nodes. The proposed structure is modified due to gate lines considerations. Total gain improvement is achieved by engineering the characteristic impedance of gate lines and also make appr...
متن کامل