Mechanism for Performing Label Switched Path Ping (LSP Ping) over MPLS Tunnels

نویسندگان

  • Nitin Bahadur
  • Kireeti Kompella
  • George Swallow
چکیده

This document describes methods for performing LSP ping (specified in RFC 4379) traceroute over MPLS tunnels and for traceroute of stitched MPLS Label Switched Paths (LSPs). The techniques outlined in RFC 4379 are insufficient to perform traceroute Forwarding Equivalency Class (FEC) validation and path discovery for an LSP that goes over other MPLS tunnels or for a stitched LSP. This document deprecates the Downstream Mapping TLV (defined in RFC 4379) in favor of a new TLV that, along with other procedures outlined in this document, can be used to trace such LSPs.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Bidirectional Forwarding Detection (BFD) for MPLS Label Switched Paths (LSPs)

One desirable application of Bidirectional Forwarding Detection (BFD) is to detect a Multiprotocol Label Switching (MPLS) Label Switched Path (LSP) data plane failure. LSP Ping is an existing mechanism for detecting MPLS data plane failures and for verifying the MPLS LSP data plane against the control plane. BFD can be used for the former, but not for the latter. However, the control plane proc...

متن کامل

RFC 5884 BFD for MPLS

One desirable application of Bidirectional Forwarding Detection (BFD) is to detect a Multiprotocol Label Switching (MPLS) Label Switched Path (LSP) data plane failure. LSP Ping is an existing mechanism for detecting MPLS data plane failures and for verifying the MPLS LSP data plane against the control plane. BFD can be used for the former, but not for the latter. However, the control plane proc...

متن کامل

Fast Reroute Extensions to RSVP-TE for LSP Tunnels

Fast Reroute Extensions to RSVP-TE for LSP Tunnels Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is u...

متن کامل

Definition of Time to Live TLV for LSP-Ping Mechanisms

LSP-Ping is a widely deployed Operation, Administration, and Maintenance (OAM) mechanism in MPLS networks. However, in the present form, this mechanism is inadequate to verify connectivity of a segment of a Multi-Segment Pseudowire (MS-PW) and/or bidirectional co-routed Label Switched Path (LSP) from any node on the path of the MS-PW and/or bidirectional co-routed LSP. This document defines a T...

متن کامل

Return Path Specified Label Switched Path (LSP) Ping

This document defines extensions to the data-plane failure-detection protocol for Multiprotocol Label Switching (MPLS) Label Switched Paths (LSPs) known as "LSP ping". These extensions allow a selection of the LSP to be used for the echo reply return path. Enforcing a specific return path can be used to verify bidirectional connectivity and also increase LSP ping robustness. Information about t...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • RFC

دوره 6424  شماره 

صفحات  -

تاریخ انتشار 2011