Influence of Traverse Speed on Surface Irregularities Created by the Abrasive Waterjet
نویسندگان
چکیده
The paper deals with the calculation of the optimal traverse speed for diff erent types of materials, which is very important for predication, imaginings and dimensioning of technological factors and selection of the materials with the aim to increase of surface quality at abrasive waterjet cutting (AWJ) technology. The surface irregularities of the experimental used materials AISI 304, AISI 309 have been measured by non-contact shadow method. New empirically compiled equations of the infl uence of the traverse speed on tensometrical state of cut, deformation resistance of material and surface roughness Ra are at AWJ cutting available.
منابع مشابه
Influence of Process Parameters on Surface Roughness in Abrasive Waterjet Cutting of Titanium
Abrasive waterjet cutting is one of the nontraditional machining processes capable of cutting wide range of hard-to-cut materials. This process incurs relatively higher initial investment, maintenance and operating costs. Therefore optimum choice of the process parameters is essential for the economic, efficient and effective utilization of this process. This paper assesses the influence of pro...
متن کاملMultiresponse Analysis in Abrasive Waterjet Machining Process on AA 6351
This study investigates optimal parameter setting in abrasive waterjet machining (AWJM) on aluminium alloy AA 6351, using taguchi based Grey Relational Analysis (GRA) is been reported. The water pressure, traverse speed and stand-off-distance were chosen as the process parameters in this study. An L 9 orthogonal matrix array is used for the experimental plan. The performance characteristics whi...
متن کاملAbrasive Water Jet Machining - A Review on Current Development
Abrasive waterjet machining (AWJM) is one of the modern machining process for difficult to cut materials. It is an environment friendly and relatively inexpensive process with reasonably high material removal rate. In all the machining processes the quality of the work piece is depends on various design parameters. The process parameters which mainly affect the quality of cutting in AWJM are Hy...
متن کاملSurface Texture in Abrasive Waterjet Cutting
When cutting thick material with an abrasive wateriet, the surface area can be characterized by two texture types. At the top of the cut, the surface texture is smooth. At the bottom, the slurry jet exiting the workpiece forms large striations in the surface. An investigation was conducted to experimentafly determine the influence of the abrasive waterjet cutting parameters on surface texture. ...
متن کاملAbrasive Water Jet Cutting (awjc) of Co-cr-mo Alloy Investment Castings in the Medical Device Industry
Investment castings (usually involving ceramic based shells) have traditionally been separated from the mould tree using an abrasive cutting operation. While material removal rates are relatively high, the process unfortunately suffers from poor accuracy control that often necessitates further finishing operations. Following an overview of key considerations in investment casting including tree...
متن کامل