Application of Laser-Burnishing Treatment for Improvement of Surface Layer Properties
نویسنده
چکیده
منابع مشابه
Analysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...
متن کاملThe burnishing effect of sodium (saline) chloride on root dentin: an in vitro study.
The purpose of this in vitro study was to evaluate the burnishing effect of saline application on dentin specimens (NaCl 0.9%). Seventy-two dentin specimens (60 experimental and 12 controls) were equally divided into two groups. In Group A; sub-groups I, II, III, IV and V were respectively soaked with saline for 5 s, 10 s, 30 s, 1 min and 2 min. Group VI was soaked in citric acid for 3 min and ...
متن کاملSynthesis of Three-Layered Magnetic Based Nanostructure for Clinical Application
The main objective of this research was to synthesize and characterize gold-coated Fe3O4 /SiO2 nanoshells for clinical applications. Magnetite nanoparticles (NPs) were prepared via co-precipitation. The results showed that smaller particles can be synthesized by decreasing the NaOH concentration, which in our case this corresponded to 35 nm by using 0.9 M of NaOH at 750 rpm. The NPs were then m...
متن کاملStudy of the lateral pass width for conventional and ultrasonic vibrations- assisted ball burnishing on Ti-6Al-4V specimens
Ball burnishing is a technological finishing process based on plastic deformation of the objective surface by means of a hard ball gliding over it. Along with its easiness of application, possible on the same machine where machining was performed [1], burnishing is a comprehensive process able to achieve surface roughness improvements, and compressive residual stresses up to deep layers of the ...
متن کاملInvestigation of Physical Properties of e-Beam Evaporated CdTe Thin Films for Photovoltaic Application
CdTe thin films with 2.8 µm thickness were deposited by electron beam evaporation method. X-ray diffraction, scanning electron microscopy, UV-Vis-NIR spectroscopy and atomic force microscopy (AFM) were used to characterize the films. The results of AFM analysis revealed that the CdTe films have uniform surface. CdTe thin films were heat-treated by SnCl2 solution. Structural analysis using XRD s...
متن کامل