Instance Analysis for the Error of Three-pivot Pressure Transducer Static Balancing Method for Hydraulic Turbine Runner
نویسندگان
چکیده
The working principle, process device and test procedure of runner static balancing test method by weighting with three-pivot pressure transducers are introduced in this paper. Based on an actual instance of a V hydraulic turbine runner, the error and sensitivity of the three-pivot pressure transducer static balancing method are analysed. Suggestions about improving the accuracy and the application of the method are also proposed.
منابع مشابه
Numerical Study of a Pipe Extension Effect in Draft Tube on Hydraulic Turbine Performance
Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...
متن کاملA Fatigue Analysis of a Hydraulic Francis Turbine Runner
In this work, the estimation of crack initiation life of a hydraulic Francis turbine runner is presented. The life prediction is based on the local strain approach to predict the initiation life. First, the analysis is carried out in air and in water condition and the runner’s natural frequencies were calculated using the finite element (FE) method. The analysis in air is compared with experime...
متن کاملInverse neural Network to Optimal Performance of the hydraulic Turbine Runner Blades
Inverse Artificial neural network (iANN) is applied to optimize the parameters for hydraulic turbine runner blades. This proposed method (iANN) inverts the artificial neural network (ANN) and uses an optimization method to find the optimum parameter value (or unknown parameter) for given required conditions. In order to do so, first an ANN, which consists of a feedforward network with one hidde...
متن کاملResonance investigation of pump-turbine during startup process
The causes of resonance of a certain model pump-turbine unit during startup process were investigated in this article. A three-dimensional full flow path analysis model which contains spiral case, stay vanes, guide vanes, runner, gaps outside the runner crown and band, and draft tube was constructed. The transient hydraulic excitation force of full flow path was analyzed under five conditions n...
متن کاملInvestigation of a High Head Francis Turbine at Runaway Operating Conditions
Hydraulic turbines exhibit total load rejection during operation because of high fluctuations in the grid parameters. The generator reaches no-load instantly. Consequently, the turbine runner accelerates to high speed, runaway speed, in seconds. Under common conditions, stable runaway is only reached if after a load rejection, the control and protection mechanisms both fail and the guide vanes ...
متن کامل