Real-time testing of the on-site warning algorithm in southern California and its performance during the July 29 2008 Mw5.4 Chino Hills earthquake
نویسندگان
چکیده
[1] The real-time performance of the tc-Pd on-site early warning algorithm currently is being tested within the California Integrated Seismic Network (CISN). Since January 2007, the algorithm has detected 58 local earthquakes in southern California and Baja with moment magnitudes of 3.0 Mw 5.4. Combined with newly derived station corrections the algorithm allowed for rapid determination of moment magnitudes and Modified Mercalli Intensity (MMI) with uncertainties of ±0.5 and ±0.7 units, respectively. The majority of reporting delays ranged from 9 to 16 s. The largest event, the July 29 2008 Mw5.4 Chino Hills earthquake, triggered a total of 60 CISN stations in epicentral distances of up to 250 km. Magnitude predictions at these stations ranged from Mw4.4 to Mw6.5 with a median of Mw5.6. The closest station would have provided up to 6 s warning at Los Angeles City Hall, located 50 km to the west-northwest of Chino Hills. Citation: Böse, M., E. Hauksson, K. Solanki, H. Kanamori, and T. H. Heaton (2009), Real-time testing of the on-site warning algorithm in southern California and its performance during the July 29 2008 Mw5.4 Chino Hills earthquake, Geophys. Res. Lett., 36, L00B03, doi:10.1029/2008GL036366.
منابع مشابه
Short Note A New Trigger Criterion for Improved Real-Time Performance of Onsite Earthquake Early Warning in Southern California
We have implemented and tested an algorithm for onsite earthquake early warning (EEW) in California using the infrastructure of the Southern California Seismic Network (SCSN). The algorithm relies on two parameters derived from the initial 3 sec of P waveform data at a single seismic sensor: period parameter τ c and high-pass filtered displacement amplitude Pd. Previous studies have determined ...
متن کاملReal-time earthquake detection and hazard assessment by ElarmS across California
[1] ElarmS is a network-based methodology for rapid earthquake detection, location and hazard assessment in the form of magnitude estimation and peak ground motion prediction. The methodology is currently being tested as part of the real-time seismic system in California leveraging the resources of the California Integrated Seismic Network (CISN) and the Advanced National Seismic System. A tota...
متن کاملApplication of real‐time GPS to earthquake early warning
[1] We explore the use of real‐time high‐rate GPS displacement data for earthquake early warning using 1 Hz displacement waveforms from the April 4, 2010, Mw 7.2 El Mayor‐Cucapah earthquake. We compare these data to those provided by the broadband velocity and accelerometer instrumentation of the Southern California Seismic Network. The unique information provided by the GPS‐based displacement ...
متن کاملFinite-Fault Rupture Detector (FinDer): Going Real-Time in Californian ShakeAlert Warning System
Rapid detection of local and regional earthquakes and issuance of fast alerts for impending shaking is considered beneficial to save lives, reduce losses, and shorten recovery times after destructive events (Allen et al., 2009). Over the last two decades, several countries have built operational earthquake early warning (EEW) systems, including Japan (Hoshiba et al., 2008), Mexico (Espinosa-Ara...
متن کاملThe Earthquake Early Warning System in southern Italy: Technologies, Methods and Performance Evaluation
A real-time seismic monitoring infrastructure has been recently installed and it is actually operating in southern Italy, whose main purposes are to rapidly issue an earthquake alert, to provide near-real-time maps of the peak ground motion and intensity shaking and to test the feasibility of earthquake early warning following moderate to large earthquakes occurring along the southern Apenninic...
متن کامل