Texture Alignment in Simple Shear
نویسندگان
چکیده
We illustrate the flow behaviour of fluids with isotropic and anisotropic microstructure (internal length, layering with bending stiffness) by means of numerical simulations of silo discharge and flow alignment in simple shear. The Cosserat theory is used to provide an internal length in the constitutive model through bending stiffness to describe isotropic microstructure and this theory is coupled to a director theory to add specific orientation of grains to describe anisotropic microstructure. The numerical solution is based on an implicit form of the Material Point Method developed by Moresi et al. [1].
منابع مشابه
Substructural Alignment during ECAE Processing of an Al-0.1Mg Aluminium Alloy
An investigation has been carried out into the microstructures developed during the early stages of equal channel angular extrusion (ECAE) in a polycrystalline single-phase Al-0.13Mg alloy, with emphasis on the substructural alignment with respect to the die geometry and the crystallographic slip systems, which is essentially related to the grain refinement and texture development during deform...
متن کاملTexture development in friction stir welds
The shear textures that develop in friction stir welds are reviewed and discussed. In all the materials examined, including face centred cubic (fcc), body centred cubic (bcc) and hexagonal close-packed (hcp) materials, friction stir welding produces a predominant shear texture with the close-packed directions aligned with the shear direction (SD) and the close-packed plane normal perpendicular ...
متن کاملTextures in experimentally deformed olivine aggregates: the effects of added water and melt
The texture development in experimentally sheared aggregates of olivine was monitored as a function of increased water content and added melt. In dry samples, an alignment of {010} with the shear plane and <100> and <001> with the shear direction, respectively, was observed, consistent with intracrystalline glide on the (010)[100] and (010)[001] slip systems. Samples with high water content sho...
متن کاملThe Effect of Cold Rolling Process on the Microstructure and Texture Evolution in a 1 wt. % Si Non-oriented Electrical Steel
In this study, the effect of cold rolling process on the microstructure and texture evolution in 1wt. % Si non-oriented electrical steel was investigated. For this purpose, all samples were processed through single-stage hot rolling at 1100 ° C and two-stage cold rolling (cross rolling and unidirectional rolling) with intermediate annealing at 650 °C for 35 seconds. Finally, all of them were fu...
متن کاملMicrostructural refining during friction stir processing of SAF 2205 duplex stainless steel
Friction stir processing (FSP) was conducted on a SAF 2205 duplex stainless steel at advancing speed of 50 mm/min and rotational speed of 400 rpm. Characterization of evolved material was studied using electron microscopy equipped with electron back scattered diffraction (EBSD) system. The results indicated that the severe plastic deformation and the heat generated during the FSP developed a v...
متن کامل