Diagnostic Analysis of Silicon Strips Detector Readout in the ATLAS Semi-Conductor Tracker Module Production
نویسنده
چکیده
The ATLAS Semi-Conductor Tracker (SCT) Collaboration is currently in the production phase of fabricating and testing silicon strips modules for the ATLAS detector at the Large Hadron Collider being built at the CERN laboratory in Geneva, Switzerland. A small but relevant percentage of ICs developed a new set of defects after being mounted on hybrids that were not detected in the wafer screening. To minimize IC replacement and outright module failure, analysis methods were developed to study IC problems during the production of SCT modules. These analyses included studying wafer and hybrid data correlations to finely tune the selection of ICs and tests to utilize the ability to adjust front-end parameters of the IC in order to reduce the rejection and replacement rate of fabricated components. This paper will discuss a few examples of the problems encountered during the production of SCT hybrids and modules in the area of ICs performance, and will demonstrate the value of the flexibility built into the ABCD3T chip. © 2001 Elsevier Science. All rights reserved
منابع مشابه
Design of the LHCb Silicon Tracker∗
The LHCb Silicon Tracker is a large-surface silicon micro-strip detector that will cover an important part of the LHCb tracking system. Its data will be used in the trigger to select high-pT daughter particles from B-meson decays, and in the offline analysis to reconstruct trajectories of charged particles in the very forward region of the detector. Readout strips of up to 38 cm in length with ...
متن کاملDouble-sided Silicon Detectors using N-side Pad Readout for the CMS Silicon Inner Tracker
Double-sided silicon detector prototypes produced for the CMS inner tracker are described which divide the n-side into pads rather than strips. The signal routing to the readout electronics is made on a separate flexible z-print which is glued on the detector and then wire-bonded to the pads.
متن کاملBeam splash effects on ATLAS silicon microstrip detectors evaluated using 1-w Nd :YAG laser
On an incident of accelerator beam loss, the tracking detector located close to the beam line is subjected to receive intensive radiation in a short period. We used a 1-W focused Nd :YAG laser and simulated the effects on the ATLAS microstrip detector. The laser corresponds to intensity of up to 1 10 mips=pulse with a pulse width of about 10 ns. We observed breaks on Al strips on extreme condit...
متن کاملConstruction of the ATLAS semi-conductor tracker (SCT) barrel modules in Japan
We have developed a semi-automated assembly system and constructed 124 silicon microstrip modules so far for the ATLAS SCT barrel. This article describes the assembly procedure, evaluations of precisions and the module survey results. A precision of B2 mm is achievable with this assembly system. r 2003 Elsevier B.V. All rights reserved.
متن کاملThe CMS Silicon Strip Tracker
The CMS collaboration is constructing the largest silicon tracker ever built with an active silicon area of 200 m2 to provide robust charged particle tracking and vertex reconstruction within the 4T magnetic field of the CMS Solenoid. The design of the detector, the status of the construction and the performance of the substructures are reviewed. PACS: 29.40.Wk, 29.40.Gx, 01.30.Cc THE CMS SILIC...
متن کامل