Change in Dielectric Properties in the Microwave Frequency Region of Polypyrrole–Coated Textiles during Aging
نویسندگان
چکیده
Complex permittivity of conducting polypyrrole (PPy)-coated Nylon-Lycra textiles is measured using a free space transmission measurement technique over the frequency range of 1-18 GHz. The aging of microwave dielectric properties and reflection, transmission and absorption for a period of 18 months is demonstrated. PPy-coated fabrics are shown to be lossy over the full frequency range. The levels of absorption are shown to be higher than reflection in the tested samples. This is attributed to the relatively high resistivity of the PPy-coated fabrics. Both the dopant concentration and polymerisation time affect the total shielding effectiveness and microwave aging behaviour. Distinguishing either of these two factors as being exclusively the dominant mechanism of shielding effectiveness is shown to be difficult. It is observed that the PPy-coated Nylon-Lycra samples with a p-toluene sulfonic acid (pTSA) concentration of 0.015 M and polymerisation times of 60 min and 180 min have 37% and 26% decrease in total transmission loss, respectively, upon aging for 72 weeks at room temperature (20 °C, 65% Relative humidity (RH)). The concentration of the dopant also influences the microwave aging behaviour of the PPy-coated fabrics. The samples with a higher dopant concentration of 0.027 mol/L pTSA are shown to have a transmission loss of 32.6% and 16.5% for short and long polymerisation times, respectively, when aged for 72 weeks. The microwave properties exhibit better stability with high dopant concentration and/or longer polymerization times. High pTSA dopant concentrations and/or longer polymerisation times result in high microwave insertion loss and are more effective in reducing the transmission and also increasing the longevity of the electrical properties.
منابع مشابه
Detection of napropamide by microwave resonator sensor using carbon nanotube – polypyrrole- chitosan layer
This paper presents the design and fabrication of proximity coupled feed disk resonator coated with Multi Walled Carbon Nanotubes (MWCNTs) and Polypyrrole-Chitosan (PPy-CHI) layers as a napropamide sensor. Computer Simulation Technology (CST) microwave studio was used to obtain the best design of disk resonator and feed line position in 5 GHz resonant frequency. Also, MWCNTs - PPy-CHI layers we...
متن کاملDielectric properties of polypyrrole doped with tosylate anion in the far infrared and microwave
We report measurements of the dielectric behavior in the far infrared ( 10-200 cm’ ) and in the microwave (8.5-12.5 GHz) regime for the conducting polypyrrole (PP) doped with tosylate anion. The dielectric constants have been determined from reflection and transmission data using the Fresnel equations. The magnitude and dispersive nature of the complex index of refraction is described for a num...
متن کاملCorrosion behavior of polypyrrole/hydroxyapatite nanocomposite thin films electropolymerized on NiTi substrates in simulated body fluid
Hydroxyapatite (HAp) nanoparticles synthesized via microwave irradiation. Polypyrrole (PPy)/HAp nanocomposite was obtained using electropolymerization on nitinol (Ni) titanium (Ti) substrates. Fourier transform infrared was employed to characterize the nanocomposite formation. Electrochemical properties of the nanocomposite were investigated using polarization and electrochemical impedance spec...
متن کاملNumerical Modeling and Experimental Study of Probe-Fed Rectangular Dielectric Resonator Antenna (RDRA) Supported by Finite Circular Ground Plane
Dielectric Resonator Antennas (DRAs) have received increased interest in recent years for their potential applications in microwave and millimeter wave communication systems. DRAs are normally used with the support of a ground plane. The radiation and impedance properties therefore depend not only on their physical dimensions and dielectric properties, but also on the size of the ground plane. ...
متن کاملEffect of milling time and microwave sintering on microhardness and electrical properties of nano and micro structured cordierite
The purpose of this research is to investigate the mechanical and electrical properties of nano structured cordierite. Nano grain size powders were synthesized through mechanical activation by high-energy ball milling of the starting powders containing 34.86 wt% Al2O3, 51.36 wt% SiO2, and 13.78 wt% MgO. Samples were prepared by conventional and microwave sintering at 1390°C. SEM observations il...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره 9 شماره
صفحات -
تاریخ انتشار 2016