Design of Array MEMS Vector Vibration Sensor in the Location of Pipeline Internal Inspector
نویسندگان
چکیده
In view of the pipeline marking difficult and poor measurement precision, a new-type monolithic integrated array MEMS vector vibration sensor has been put forward. It has overcomed the deficiency that present vector acoustic sensor applied in the oil and gas pipeline internal inspector can not be accurate about signal position, and eliminated the port/starboard blur problem. Through ANSYS simulation analysis, it conclude that the array vector vibration sensor has the sensitivity of 2.05mv/pa (-173.8dB,0dB=1v/μpa). The first-order modal is 438 Hz, and the third-order modal is 452 Hz. The resonance frequency of the two sensitive components is respectively 452 Hz and 438 Hz. At the end of this paper, the algorithm that can be used to estimate the azimuth angle detected by the sensor , is given.
منابع مشابه
Design and Simulation of a Fluidic Micro-Bio-Sensor Based on Resonator Array
In this paper, a fluidic biosensor with possibility to fabricate by Micro-Electro-Mechanical Systems (MEMS) technology is proposed for biomedical mass detection and lab-on-chip applications. This is designed by electromechanical coupling of harmonic micromechanical resonators with harmonic springers as a mechanical resonator array. It can disperse mechanical wave along the array by electrostati...
متن کاملAnalytical Approach for Vibration Analysis of a Microsensor with Two layers of Silicon and Piezoelectric based on MCST
The vibration analysis is an important step in the design and optimization of microsensors. In most of the cases, COMSOL software is employed to consider the size-dependency on the dynamic behavior in the MEMS sensors. In this paper, the Modified Couple Stress Theory (MCST) is used to capture the size effect on dynamic behavior in a microsensor with two layers of the silicon and piezoelectric. ...
متن کاملDesign of Novel High Sensitive MEMS Capacitive Fingerprint Sensor
In this paper a new design of MEMS capacitive fingerprint sensors is presented. The capacitive sensor is made of two parallel plates with air gap. In these sensors, the capacitance changes is very important factor. It is caused by deformation of the upper electrode of sensor. In this study with making slots in upper electrode, using T-shaped protrusion on diaphragm in order to concentrate the f...
متن کاملPhased array antenna using MEMS phase shifter
This article presents a phased array antenna employing MEMS phase shifter. The proposed phased array antenna consists of eight square patch antennas operating at 10.4 GHz with a bandwidth of 400 MHz. Feed line for each patch passes through a MEMS phase shifter realized by a series of bridges above the transmission line. The distance between the bridge and the transmission line underneath it is ...
متن کاملSuspension Vibration Compensation Using a Mems Microactuator in Hard Disk Drives
This paper discusses the design and fabrication of a prototype MEMS microactuator and vibration sensors, and controller design for suspension vibration compensation in disk drives. The microactuator utilizes parallel-plates actuation and comb-finger position sensing. An electrical isolation MEMS fabrication technique is utilized to increase the actuation force. An LQG method is proposed for vib...
متن کامل