Microstrip-Slot Coupler Design—Part I: S-Parameters of Uncompensated and Compensated Couplers
نویسندگان
چکیده
Using the even-odd mode anafysis of four-port networks with double symmetry, the scattering parameters of the microstrip-slot coupler are derived from the evenand odd-mode parameters of the coupler cross section. The uncompensated coupler and the coupler compensated by extending tbe slot fines are treated and desigo specifications are given covering the compensation slot lines. A comparison with experimental data will be given in Part II.
منابع مشابه
Microstrip-Slot Coupler Design—Part II: Practical Design Aspects
Practical aspects of designing microstrip-slot couplers on an AI ~03 ceramic substrate (e, = 9.8) are treated in supplementation of the theoretical analysis of the coupler presented in Part I. Comparison with implemented couplers yields rules for specification of the reference planes at the ends of the coupling section and for the appropriate choice of definition for the slot-line characteristi...
متن کاملDesign of a Novel 3 Db Microstrip Backward Wave Coupler Using Defected Ground Structure
In this paper an edge coupled microstrip coupler with defected ground structure is presented. A normally 7 dB coupler designed on Alumina substrate is converted into a 3 dB coupler by cutting single rectangular slot in the ground plane encompassing the two transmission lines. Other properties of backward wave coupler remain the same, except for a tighter coupling. With this method of design opt...
متن کاملDevelopment of Forward-wave Directional Couplers Loaded by Periodic Shunt Shorted Stubs
In this paper a new procedure for designing forward-wave directional couplers using periodic shunt short circuited stubs is proposed. A new type of cell using these stubs, which enlarge the phase difference between even- and odd modes of a uniform microstrip coupled line is introduced. Using the equivalent circuit model for even- and odd-modes of the proposed cell, the elements of the ABCD tra...
متن کاملDesign and Simulation of Microstrip Directional Coupler with Tight Structure and High Directivity*
The design of Cyclotron CYCHU-10 has been carried out at Huazhong University of Science and Technology (HUST). Because of the low centre frequency (99MHz) of its RF system, we should choose suitable directional couplers for the RF system which is supposed to be highdirectivity and tight-structure. This paper analyzes and synthesizes kinds of directional couplers, especially microstrip structure...
متن کاملMoM Analysis and Design of a Compact Coaxial-to-Microstrip Directional Coupler
In order to overcome the main drawbacks of coaxial, waveguide, and stripline couplers, the analysis and the design of a compact coaxial-to-microstrip directional coupler convenient for power and antenna control application, are presented using the method of moments (MoM) in two dimensions. This technique is adapted to study the complex configuration of the line’s system, which does not have a s...
متن کامل