Chatter Suppression in a High Speed Magnetic Spindle by Adding Damping
نویسندگان
چکیده
Magnetic bearings are used in several applications, but they didn’t succeed in the machine tool industry, due basically to their low damping, with its associated low chatter free cutting capacity. This work shows the development of a high speed milling spindle supported on magnetic bearings with high chatter resistance. That is achieved by using control strategies which add damping to the bearings. Excitation by means of the magnetic bearings is used to identify its dynamic behaviour and to optimize the damping parameters. Finally the results of the industrial validation are presented; showing an increase of six times in the cutting capacity.
منابع مشابه
Experimental Passive Suppression of the Regenerative Chatter Phenomenon by Variation of the Frequency and Amplitude of the Spindle Motor Excitation in Turning
The suppression of the regenerative chatter phenomenon in turning process via the variation of the frequency and amplitude of the spindle motor excitation is carried out in this research. A programmable inverter is employed for variable periodic excitation of the spindle motor. A set of turning experiments is designed and performed on a number of conical work pieces both in constant spindle spe...
متن کاملExperimental Passive Suppression of the Regenerative Chatter Phenomenon by Variation of the Frequency and Amplitude of the Spindle Motor Excitation in Turning
The suppression of the regenerative chatter phenomenon in turning process via the variation of the frequency and amplitude of the spindle motor excitation is carried out in this research. A programmable inverter is employed for variable periodic excitation of the spindle motor. A set of turning experiments is designed and performed on a number of conical work pieces both in constant spindle spe...
متن کاملChatter Stability Characterization of Full-Immersion End-Milling Using a Generalized Modified Map of the Full-Discretization Method, Part 1: Validation of Results and Study of Stability Lobes by Numerical Simulation
The objective in this work is to generate and discuss the stability results of fully-immersed end-milling process with parameters; tool mass m 0.0431kg, tool natural frequency 5700 rads , damping factor ξ 0 . 0 2 and workpiece cutting coefficient C 3.5 10 Nm ⁄ . Different no of teeth is considered for the end-milling. Both 1-DOF and 2-DOF chatter models of the system are generated on the basis ...
متن کاملApplication of Spindle Speed Variation for Chatter Suppression in Turning
In the present paper the chatter instability of variable speed machining is studied. Though, there exist numerical methods for the computation of the stability lobes for variable speed machining, especially in turning processes the potential of an active spindle speed variation for chatter suppression is mostly unexploited. In the case of a slowly time-varying spindle speed, which is practicabl...
متن کاملProcess Damping Analytical Stability Analysis and Validation
INTRODUCTION The analytical stability lobe diagram offers a predictive capability for selecting stable chip width-spindle speed combinations in machining operations [1-4]. However, the increase in allowable chip width provided at spindle speeds near integer fractions of the system’s dominant natural frequency is diminished substantially at low spindle speeds where the stability lobes are closel...
متن کامل