W-Band Coverage in 32nm SOI CMOS

CMOS VCOs have been implemented for mm-wave applications [1-7], however, as the required channel bandwidth for these applications increases, widerange VCO tuning is becoming more challenging. Even without taking into account the process variability in nanometer CMOS, a single VCO hardly achieves requirements for a mm-wave band and phase-noise performance, and it suffers from the steep VCO loop gain. Taking advantage of parallelism, using an array of VCOs is emerging as an alternative technique to implement a wide-band VCO (Fig. 16.3.1). While nanometer CMOS technology is becoming the next generation RF and mm-wave platform (because of high-speed performance due to technology scaling and and SoC integration capability), costly technology developments and mask sets further promote the use of array-based VCOs to expedite yield learning and circuit-development cycle. However, a VCO array requires more circuit area. Conventional designs are not scalable because of their size, cost, and complications for signal delivery. Technology scaling for mm-wave SoC is driven by the high-speed device performance while digital systems benefit from increased device density. In mmwave applications, passive components, especially inductors, are responsible for area budget, since their area is not scaled with the technology. Taking advantage of nanometer FETs, the presented complementary LC-VCO is attractive for VCO arrays. It uses an LC-tank and its area is minimal and highly scalable. The use of state-of-the-art nanometer CMOS technology is essential to retain high-speed design margin for mm-wave circuits and provisions are required to make the complementary LC-VCO more scalable and manufacturable against the process variability and technology uncertainty. After all, the VCO array provides mm-wave-component performance-variability metrics as a feedback to the technology foundry. Such components are difficult and expensive to characterize and the required on-chip probe pads waste silicon area.