Enhancement in the efficiency of polymerase chain reaction by TiO2 nanoparticles: crucial role of enhanced thermal conductivity.

نویسندگان

  • R Abdul Khaliq
  • Parshuram J Sonawane
  • Binu K Sasi
  • Bhavani S Sahu
  • T Pradeep
  • Sarit K Das
  • Nitish R Mahapatra
چکیده

Improvement of the specificity and efficiency of the polymerase chain reaction (PCR) by nanoparticles is an emerging area of research. We observed that TiO(2) nanoparticles of approximately 25 nm diameter caused significant enhancement of PCR efficiency for various types of templates (namely plasmid DNA, genomic DNA and complementary DNA). By a series of experiments, the optimal TiO(2) concentration was determined to be 0.4 nM, which resulted in up to a seven-fold increase in the amount of PCR product. As much as 50% reduction in overall reaction time (by reduction of the number of cycles and the time periods of cycles) was also achieved by utilizing TiO(2) nanoparticles without compromising the PCR yield. Investigations of the mechanism of such PCR enhancement by simulations using the 'Fluent K epsilon turbulent model' provided evidence of faster heat transfer in the presence of TiO(2) nanoparticles. Consistent with these findings, TiO(2) nanoparticles were observed to augment the denaturation of genomic DNA, indicating more efficient thermal conductivity through the reaction buffer. TiO(2) nanoparticle-assisted PCR may be useful for profound reduction of the overall PCR reaction period and for enhanced amplification of DNA amplicons from a variety of samples, including GC-rich templates that are often observed to yield unsatisfactory results.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An experimental assessment of nanostructured materials embedded in a PCM-based heat sink for transient thermal management of electronic

In the present paper, an experimental assessment was performed on the transient thermal performance of a heat sink filled by a phase change material (PCM) and PCM embedded with carbon nanofibers (CNFs) and titania (TiO2) nanoparticles as nanostructured materials. In order to enhance the thermal conductivity of PCM, CNFs and TiO2 nanoparticles at different loadings (0.5wt. % and 2 wt.% of CNFs a...

متن کامل

Temperature-dependent effect of percolation and Brownian motion on the thermal conductivity of TiO2-ethanol nanofluids.

Ethanol-based nanofluids have attracted much attention due to the enhancement in heat transfer and their potential applications in nanofluid-type fuels and thermal storage. Most research has been conducted on ethanol-based nanofluids containing various nanoparticles in low mass fraction; however, to-date such studies based on high weight fraction of nanoparticles are limited due to the poor sta...

متن کامل

Optimization of Thermal Conductivity of Al2O3 Nanofluid by Using ANN and GRG Methods

Common heat transfer fluids such as water, ethylene glycol, and engine oil have limited heat transfer capabilities due to their low heat transfer properties. Nanofluids are suspensions of nanoparticles in base fluids, a new challenge for thermal sciences provided by nanotechnology. In this study, we are to optimize and report the effects of various parameters such as the ratio of the thermal co...

متن کامل

Experimental investigation and proposed correlations for temperaturedependent thermal conductivity enhancement of ethylene glycol based nanofluid containing ZnO nanoparticles

Experimental study of effective thermal conductivity of ZnO/EG nanofluid is presented in thisresearch. The nanofluid was prepared by dispersing Zno nanoparticles in ethylene glycol using asonicator and adding surfactant. Ethylene glycol based nanofluid containing ZnO nanoparticlewith a nominal diameter of 18 nm at different solid volume fractions (very low to high) atvarious temperatures was ex...

متن کامل

Thermal and electrical conductivity of Aluminium Nitride nanofluids

This study was designed to experimentally measure the thermal and electrical conductivities of Aluminium Nitride/Ethylene Glycol (AlN/EG) nanofluids. Transmission electron microscopy (TEM) was used to characterize the shape of AlN nanoparticles. Nanofluids with different particle volume concentrations of 0.5%, 1%, 2%, 3%, 4%, and 5% were utilized. The thermal and electrical conductivities of the...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Nanotechnology

دوره 21 25  شماره 

صفحات  -

تاریخ انتشار 2010