Tetra-Frequency Microstrip Antenna for Wireless Applications
نویسندگان
چکیده
In this paper, the design, fabrication and measurement of a microstrip patch antenna is reported which can be operated at four frequencies – 5.215 GHz, 5.5 GHz, 5.69 GHz and 6.16 GHz. The simulation is done using IE3D software.
منابع مشابه
A compact stacked Quasi-fractal microstrip antenna for RFID applications
In this paper, we propose a new compact quasi-fractal shaped microstrip antenna that consists of a hexagonal patch as the main radiator and a complementary stacked patch as the parasitic element. The overall surface of the proposed quasi-fractal patch is about 55% lower than the conventional hexagonal patch. Using of stacked technique, the gain reduction of compression technique is almost compe...
متن کاملModified Rectangular Patch Antenna Loaded With Multiple C Slots for Multiple Applications
A new multiple C-slotted microstrip patch antenna is proposed in the present study. A patch antenna is a wide-beam narrowband antenna. The microstrip patch antenna consists of a very thin metallic strip (patch) placed a small fraction of a wavelength above a ground plane. The patch can be designed in any possible shape and normally made of conducting materials such as copper or gold. This study...
متن کاملA New Compact Ultra-wideband Linear Antenna Array for Target Detection Applications
This paper presents a low-cost compact planar microstrip-fed monopole antenna and its four-element array design for ultra-wideband (UWB) wireless communication and target detection applications, respectively, operating in the frequency span of 3 GHz to 11 GHz. A prototype was fabricated and then measured based on optimal parameters. The results of reflection coefficient (S11) and radiation patt...
متن کاملInvestigations on A New Proximity Coupled Dual-Frequency Microstrip Antenna for Wireless Communication
The investigations on a new proximity coupled dualfrequency microstrip antenna, which can be operated at GPS and Bluetooth frequency bands of wireless communication, are reported. The patch geometry consists of two square sections joined at the common corners and proximity coupled by a microstrip line. The results show that the antenna has sufficient bandwidth and gain necessary for the above f...
متن کاملA Capacitive Fed Microstrip Patch Antenna with Air Gap for Wideband Applications (RESEARCH NOTE)
In this paper a microstrip antenna on a suspended substrate with capacitive feed is presented. capacitive feed is created by a slot within the rectangular patch around the feed point. The proposed antenna exhibits a much higher impedance bandwidth of about 47% (S11 < −10 dB). Effects of key design parameters such as the air gap between the substrate and the ground plane, the gap width between r...
متن کامل