Stresses induced in alloys by selective oxidation

نویسندگان

  • Z. Suo
  • A. G. Evans
چکیده

Consider a substitutional solution of two metallic elements A and B. When the alloy is exposed to air at an elevated temperature, A oxidizes, but B does not. In the alloy, the two elements diffuse in opposite directions, but usually at different rates; the nonreciprocal diffusion is known as the Kirkendall effect. At the oxide-alloy interface, metallic atoms may either emit from or inject into the interior of the alloy. Both the nonreciprocal diffusion and the interfacial process generate stress in the alloy, while creep relaxes the stress. If tensile, this stress could generate voids. This paper formulates governing equations both in the alloy and at the interface. Numerical examples are given for nickelaluminum alloys. The stress in the alloy near the interface can be either tensile or compressive, depending on the oxidation mechanism, as well as on the relative diffusion rates of Ni and Al.  2002 Acta Materialia Inc. Published by Elsevier Science Ltd. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

High Temperature Erosion- Oxidation Behavior of Nickel- Based Alloys Containing Mo in Fluidized Bed Waste Incineration

High-temperature erosion-oxidation behavior of nickel-based alloys containing 0-7 wt.% Mo in fluidized bed waste incineration conditions was studied. A stream of hot condensed air with a flow rate of 25 L/min caused hot silica sand (700 °C) mixed with 0.5 wt.% of chloride salts to hit the specimens for 250 h. By removing the erosive factor, the high-temperature oxidation behavior of the alloys ...

متن کامل

EFFECT OF ANODIC OXIDATION ON THE CORROSION BEHAVIOR OF NICKEL-TITANIUM SHAPE MEMORY ALLOYS IN SIMULATED BODY FLUIDS (SBF)

The effect of anodic oxidation of a NiTi shape memory alloy in sulfuric acid electrolyte on its surface characteristics was studied. Surface roughness was measured by roughness tester. Surface morphology was studied using optical microscopy (OM) and scanning electron microscopy (SEM). Corrosion behavior was specified by recording Potentiodynamic polarization cur...

متن کامل

Measurement of the strains induced upon thermal oxidation of an alumina-forming alloy

The mechanisms that govern the formation of a thermally grown alumina on Al-containing super-alloys has been the subject of much recent speculation, because of the key influence of this oxide on the durability of thermal barrier systems for gas turbines. Among the important issues to be resolved are the location of the new oxide growth (interface, surface or internal grain boundary), the strain...

متن کامل

Relation between composition, microstructure and oxidation in iron aluminides

The relation between chemical composition, microstructure and oxidation properties has been investigated on various FeAl based alloys, the aim being to induce changes in the microstructure of the compound by selective oxidation of aluminium. Oxidation kinetics that was evaluated on bulk specimens showed that, due to fast diffusion in the alloys, no composition gradient is formed during the alum...

متن کامل

Selective oxidation of sulfides to sulfoxides by a vanadium-based catalyst using 30% hydrogen peroxide

The vanadium-based catalyst, acts as a homogeneous catalyst for the selective oxidation of various kinds of sulfides with 30% aqueous H2O2. Vanadium-based catalyst was successfully used as the oxygen source for the oxidation of sulfides to sulfoxides for the first time. The sulfoxides were obtained in a good way to high yields without any detectable over-oxidation to sulfones under normal condi...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2002