Composition-dependent structure of polycrystalline magnetron-sputtered V–Al–C–N hard coatings studied by XRD, XPS, XANES and EXAFS
نویسندگان
چکیده
V-Al-C-N hard coatings with high carbon content were deposited by reactive radio-frequency magnetron sputtering using an experimental combinatorial approach, deposition from a segmented sputter target. The composition-dependent coexisting phases within the coating were analysed using the complementary methods of X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), X-ray absorption near-edge spectroscopy (XANES) and extended X-ray absorption fine-structure spectroscopy (EXAFS). For the analysis of the X-ray absorption near-edge spectra, a new approach for evaluation of the pre-edge peak was developed, taking into account the self-absorption effects in thin films. Within the studied composition range, a mixed face-centred cubic (V,Al)(C,N) phase coexisting with a C-C-containing phase was observed. No indication of hexagonal (V,Al)(N,C) was found. The example of V-Al-C-N demonstrates how important a combination of complementary methods is for the detection of coexisting phases in complex multi-element coatings.
منابع مشابه
Effect of Substrate Bias Voltage and Ti Doping on the Tribological Properties of DC Magnetron Sputtered MoSx Coatings
Molybdenum disulfide (MoS2) is one of the most widely used solid lubricants. In this work, composite MoSx/Ti coatings were deposited by direct-current magnetron sputter ion plating onto plain carbon steel substrates. The MoSx/Ti ratio in the coatings was controlled by sputtering the composite targets. The composition, microstructure, and mechanical properties of the coatings were explored using...
متن کاملNanostructural studies of PVD TiAlB coatings
TiAlB coatings with different compositions were deposited by co-sputtering from TiAl and TiB2 targets onto AISI316 stainless steel substrates at a temperature of 170(C. The stoichiometry and nanostructure have been studied by x-ray photoelectron spectroscopy (XPS), x-ray diffraction (XRD) and transmission electron microscopy (TEM). Analysis of the XPS spectra suggests the presence of phases in ...
متن کاملChemical and Morphological Characterization of Magnetron Sputtered at Different Bias Voltages Cr-Al-C Coatings
MAX phases (M = transition metal, A = A-group element, and X = C/N) are of special interest because they possess a unique combination of the advantages of both metals and ceramics. Most attention is attracted to the ternary carbide Cr2AlC because of its excellent high-temperature oxidation, as well as hot corrosion resistance. Despite lots of publications, up to now the influence of bias voltag...
متن کاملThe influence of discharge power and heat treatment on calcium phosphate coatings prepared by RF magnetron sputtering deposition
Ca-P coatings with different Ca/P ratio and composition were successfully prepared by RF magnetron sputtering deposition. The Ca/P ratio, phase composition, structure and morphological properties were characterized by XRD, FTIR, EDS and SEM analyses. All the as-sputtered coatings were amorphous and after IR-irradiation the coatings altered into a crystalline phase. The obtained coatings had a C...
متن کاملTailored synthesis of nanostructured WC/a-C coatings by dual magnetron sputtering
Nanostructured coatings with variable contents of tungsten carbide (WC) and amorphous carbon (a-C) are prepared by controlling the sputtering power ratio using WC and graphite targets. XRD and TEM/ED analysis shows that increasing the C incorporation, the WC nanocrystalline phases evolve from γ-W2C to β-WC1-x. Further C enrichment leads to a nanocomposite structure of small WC1-x crystals dispe...
متن کامل