Design and Performance Analysis of D-STATCOM for Non-linear Load Composite Compensation
نویسندگان
چکیده
This paper investigates the design,analysis and simulation of a Distribution-STATic COMpensator(D-STATCOM) for non-linear load Composite(harmonic and reactive power) compensation on a three phase bus network. Composite compensation is achieved by implementation of a p-q controller, which monitors the load current and injects equal amplitude and opposite phase compensation currents to neutralize load reactive power and harmonics. This ensures the source current remains fundamental. This paper simulated results in MATLAB platform and showed that a D-STATCOM is suited for use in reactive power and harmonic compensation on any bus on a power system network.
منابع مشابه
Harmonic Compensation using STATCOM for SEIG Feeding Single-Phase Load Connected between Different Phases
The paper presents the analysis of harmonic distortion when non-linear load is connected in different phases of power system with STATCOM for singly excited induction generator system with wind turbine as prime mover. Now-a-days due to the drastically increased in use of non linear loads causes many power quality problems in power system network. Those problems are classified as reactive power ...
متن کاملDesign and Implementation of a STATCOM Based on a Multilevel FHB Converter with Delta-Connected Configuration for Unbalanced Load Compensation
A delta-connected STATCOM with cascade multilevel full H-bridge (FHB) converter has been applied for phase balancing and power factor correction of unbalanced load in a three-phase, three-wire power distribution system. In this paper, a feedforward compensation formula is presented for the STATCOM by using the symmetrical components method to compensate unbalanced load. Computer simulation is p...
متن کاملIdentification and Elimination of Faults Occurrence in sub- systems by using Resistance Switching for Linear Loads through Distribution Statcom (D-STATCOM)
This Paper presents the orientation procedure for diagnosing the power quality problems in different fault occurring conditions by using Distribution STATCOM (DSTATCOM) with linear loads. Here the resistance switching is used to get the pure sinusoidal voltage compensation. This modelling and simulation of D-STATCOM is achieved by using pure sinusoidal Pulse Width Modulation Technique. The majo...
متن کاملStability Analysis of Laminated Cylindrical Shells under Combined Axial Compression and Non-Uniform External Pressure
This study investigates geometrical non-linear analysis of composite circular cylindrical shells under external pressure over part of their surfaces and also shells subjected to combined axial compression and triangular external pressure. Donnell non-linear shell theory along with first order shear deformation theory (FOSD) are adopted in the analysis. In the case of combined axial compression ...
متن کاملA Coordinated Control Scheme for Improving Voltage Quality Using Power Electronics Interfaced DGs
Recently, increasing of non-linear loads in the power distribution network has been increased harmonics in these networks. The harmonics problems get worse and complicated by installation of power factor correction capacitors and filters. But the Distributed Generations (DGs) interface inverters with properly control can help to improve power quality, harmonic compensation and voltage unbalance...
متن کامل