Mechanics of a liquid drop deposited on a solid substrate
نویسنده
چکیده
New derivations of Young–Laplace’s and Young’s equations for a liquid drop deposited on a smooth solid substrate are presented, based on an integral form of equilibrium conditions applied to appropriately selected finite portions of the drop. A simple proof for the gravity independence of the contact angle is constructed and compared with a commonly utilized but more involved proof based on the energy minimization. It is demonstrated that the vertical component of the adhesive force along a triple contact line does not depend on the specific weight of the liquid, provided that the line tension along a triple contact is ignored. The uplifting of the surface of the substrate due to vertical force is calculated by using a linear elasticity theory. The resulting singularity in the vertical displacement and the discontinuity in the radial displacement along a triple contact line are eliminated by incorporating in the analysis the effective width of the triple contact region. It is shown that the radial displacement vanishes on the surface of the substrate outside its contact with a deposited drop.
منابع مشابه
Pearl drops
– If deposited on a hydrophobic rough substrate, a small drop of water can look like a pearl, with a contact angle close to 180. We examine the conditions for observing such a phenomenon and show practical achievements where the contact angle can be predicted and thus quantitatively tuned by the design of the surface microstructure. Presentation. – The contact angle of a drop on a solid is idea...
متن کاملTribological behavior of sputter-deposited MoSX/Ni coatings
AbstractSputtered MoS2 coatings have been mostly used as a solid lubricant. In this investigation, MoSx/Ni composite coatings with Ni contents varying from 0 to 22 % were deposited onto steel substrate using a DC magnetron sputter process. The MoS2/Ni ratio in the coatings was controlled by sputtering the composite targets. The composition, microstructure, and mechanical properties of the...
متن کاملParticle Fabrication Using Inkjet Printing onto Hydrophobic Surfaces for Optimization and Calibration of Trace Contraband Detection Sensors
A method has been developed to fabricate patterned arrays of micrometer-sized monodisperse solid particles of ammonium nitrate on hydrophobic silicon surfaces using inkjet printing. The method relies on dispensing one or more microdrops of a concentrated aqueous ammonium nitrate solution from a drop-on-demand (DOD) inkjet printer at specific locations on a silicon substrate rendered hydrophobic...
متن کاملVery thin solid-on-liquid structures: the interplay of flexural rigidity, membrane force, and interfacial force
This paper studies a solid film lying on a liquid layer, which in turn lies on a solid substrate. It is well known that, subject to a compressive membrane force, the solid film wrinkles, dragging the liquid underneath to flow. When the solid film is very thin, the ratio between the number of atoms at the surface and that in the bulk becomes significant, so that surface stress contributes to the...
متن کاملWater spring: a model for bouncing drops
– It has been shown that a water drop can bounce persistently, when thrown on a super-hydrophobic substrate. We present here scaling arguments which allow us to predict the maximal deformation and the contact time of the drop. This approach is completed by a model describing the flow inside the drop, and by original experimental data. Introduction. – A liquid ball is a drop which remains quasi-...
متن کامل