The Design and Operation of a MEMS Differential Scanning Nanocalorimeter for High-Speed Heat Capacity Measurements of Ultrathin Films
نویسندگان
چکیده
A MEMS sensor has been developed for use as a calorimetric cell in an ultra-sensitive, thin-film, differential scanning calorimetric technique. The sensor contains a freestanding, thin (30 nm to 1000 nm), low-stress silicon nitride membrane with lateral dimensions of a few millimeters. This membrane, along with a thin (50 nm) metallization layer, forms a calorimetric cell with an exceptionally small addenda. This small addenda creates a very sensitive calorimetric cell, able to make heat capacity measurements of nanometer-thick metal and polymer films. The sensor fabrication and various design considerations are discussed in detail. The calorimetric technique and examples of applications are described. [891]
منابع مشابه
Deposition of ultrathin rare-earth doped Y2O3 phosphor films on alumina nanoparticles
Ultrathin films of Eu3+ doped Y2O3 were deposited onto alumina nanoparticles using a unique solution synthesis method. The surface structure, composition, and morphology of the thin films deposited were analysed using high resolution transmission electron microscopy (TEM) and high angle annular dark field scanning TEM imaging and energy dispersive x-ray measurements. The films deposited were ex...
متن کاملPhotoemission measurements of Ultrathin SiO2 film at low take-off angles
The surface and interfacial analysis of silicon oxide film on silicon substrate is particularly crucial in the nano-electronic devices. For this purpose, series of experiments have been demonstrated to grow oxide film on Si (111) substrate. Then these films have been used to study the structure of the film by using X-ray photo emission spectroscopy (XPS) technique. The obtained results indicate...
متن کاملCrystallization Kinetics of Hydroxyapatite Nano-films on Stainless Steel Through a Sol-Gel Process
This article describes the preparation and analysis of nano hydroxyapatite (HA) films on stainless steel 316L through sol-gel technique. The process started with preparation of a nitrate and phosphate sol. After aging the sol for 24 h at room temperature a SS316 substrate was dip-coated and heat-treated at 350 to 450 °C for different times in air. The coating phase and structure on subs...
متن کاملDesign and simulation of a RF MEMS shunt capacitive switch with low actuation voltage, low loss and high isolation
According to contact type, RF MEMS switches are generally classified into two categories: Capacitive switches and Metal-to-Metal ones. The capacitive switches are capable to tolerate a higher frequency range and more power than M-to-M switches. This paper presents a cantilever shunt capacitive RF MEMS switch with characteristics such as low trigger voltage, high capacitive ratio, short switchin...
متن کاملPhased array antenna using MEMS phase shifter
This article presents a phased array antenna employing MEMS phase shifter. The proposed phased array antenna consists of eight square patch antennas operating at 10.4 GHz with a bandwidth of 400 MHz. Feed line for each patch passes through a MEMS phase shifter realized by a series of bridges above the transmission line. The distance between the bridge and the transmission line underneath it is ...
متن کامل