Integrated optical waveguide and photodetector arrays based on comb-like ZnO structures.

نویسندگان

  • Afsal Manekkathodi
  • Yi-Jen Wu
  • Li-Wei Chu
  • Shangjr Gwo
  • Li-Jen Chou
  • Lih-Juann Chen
چکیده

On-chip integrations of photonic waveguides and high-performance electrically-driven devices, by combining different active or passive optical components, are imperative towards the advancement of nanophotonic circuitry systems. We experimentally demonstrate the collective optical functionalities of ZnO microstructures towards designing an integrated photonic system by combining the optical waveguiding and detection properties. Comb-like microstructures composed of periodic arrays of smooth, single-crystalline ZnO nanowires are synthesized for these purposes. We demonstrate that ZnO comb structures could be used as optical waveguides, which can manipulate the blue, green, and red laser beams to an interconnected waveguide array. These results are substantiated by extensive investigation of waveguiding properties of single, stacked or crossbar nanowires, and different branched microstructures. These waveguide arrays can be successfully coupled with another ZnO comb-based photodetector and the collective performances of the integrated optical micro-device units are investigated in detail. This study shows that ZnO comb-based optical waveguide arrays have the great potential to be used as a bottom-up strategy for the construction of various miniaturized photonic demultiplexer systems.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fast UV detection by Cu-doped ZnO nanorod arrays chemically deposited on PET substrate

Well-aligned Cu-doped ZnO nanorods were successfully synthesized on polyethylene terephthalate (PET) substrate using chemical bath deposition method. The structural and optical properties of Cu-doped ZnO nanorods were investigated using X-ray diffraction (XRD), field-emission scanning electron microscopy (FESEM), energy dispersive X-ray spectroscopy (EDX) and photoluminescence (PL) spectroscopy...

متن کامل

Fabrication of Ultraviolet Photodetector Based on ZnO Nanostructures and Calcium Impurities Using Sol-Gel Method

In this paper an ultraviolet (UV) photodetector has been fabricated using ZnO nanostructures. The cheap fabrication process, high-quality nanostructures and the desired results for the photodetector are the most important characteristics of the proposed method. ZnO nanostructures have been grown using sol-gel method. In order to increase the sensitivity, calcium impurities have been added to na...

متن کامل

Substrate-Embedded and Flip-Chip-Bonded Photodetector Polymer-Based Optical Interconnects: Analysis, Design, and Performance

The performance of three optoelectronic structures incorporating substrate-embedded InP-based inverted metal–semiconductor–metal photodetectors and/or volume holographic gratings are analyzed and compared at the primary optical communication wavelengths. These structures, in conjunction with optical-quality polymer layers, can be easily integrated into silicon microelectronic substrates for the...

متن کامل

Investigating the Properties of an Optical Waveguide Based on Photonic Crystal with Point Defect and Lattice Constant Perturbation

In this paper, a photonic crystal waveguide with point defects and lattice constant perturbations of +5%, -5% are being investigated. Firstly waveguide structures with constant and specific parameters are being studied and photonic band gap diagrams for TE/TM modes are depicted; then pulse propagation in the frequencies available in the band gap are shown. After that, effects of parameters like...

متن کامل

Design Investigation of Microstrip Patch and Half-Mode Substrate Integrated Waveguide Cavity Hybrid Antenna Arrays

In this paper two linear arrays including a linear 1×4 and a planar 2×2 of microstrip patch and half-mode substrate integrated waveguide (SIW) cavity hybrid antenna are introduced and investigated. These are simply implemented using low cost single layer printed circuit board (PCB) process. The array element consists of a rectangular microstrip patch with appropriate dimensions in the vicinity ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Nanoscale

دوره 5 24  شماره 

صفحات  -

تاریخ انتشار 2013