An experimental investigation on the trailing edge cooling of turbine blades
نویسندگان
چکیده
ational Laborator 016/j.jppr.2012.10 thor. [email protected] r responsibility o ronautics, China. Abstract An experimental study was conducted to quantify the flow characteristics of the wall jets pertinent to trailing edge cooling of turbine blades. A high-resolution stereoscopic particle image velocimetry (PIV) system was used to conduct detailed flow field measurements to quantitatively visualize the evolution of the unsteady vortices and turbulent flow structures in the cooling wall jet streams and to quantify the dynamic mixing process between the cooling jet stream and the mainstream flows. The detailed flow field measurements were correlated with the adiabatic cooling effectiveness maps measured by using pressure sensitive paint (PSP) technique to elucidate underlying physics in order to explore/optimize design paradigms for improved cooling effectiveness to protect the critical portions of turbine blades from harsh environments. & 2012 National Laboratory for Aeronautics and Astronautics. Production and hosting by Elsevier B.V. All rights reserved.
منابع مشابه
Simulating Cooling Injection Effect of Trailing Edge of Gas Turbine Blade on Surface Mach Number Distribution of Blade
In this research, a gas turbine blade cascade was investigated. Flow analysis around the blade was conducted using RSM and RNG.K-ε turbulence modeling and it is simulated by Fluent software. The results were considered for the cases as Mach number loss at the trailing edge of blade caused by vortexes that were generated at the end of blade. Effect of cooling flow through the trailing edge on th...
متن کاملStudy of Trailing-Edge Cooling Using Pressure Sensitive Paint Technique
An experimental investigation was conducted to study the effects of blowing ratio and the existence of lands on the film cooling effectiveness of a turbine blade trailing-edge model. Instead of using a temperature-based technique, a mass transfer analogywas used to quantify the film cooling effectiveness. This was done through themeasurement of the distribution of oxygen concentration over the ...
متن کاملExperimental Investigation into the Hydrodynamics Effects of Slot Film Cooling on a Cylindrical Model
An experimental study of hydrodynamics of film cooling is performed by using a single longitudinal slot on a cylindrical model simulated to the leading edge of the gas turbine blade. The model is set up into the test section of an open-circuit induced flow wind tunnel which provides the main flow. The injected air, as a secondary film flow, produced from a high pressure compressor is considered...
متن کاملNumerical Study of a Pipe Extension Effect in Draft Tube on Hydraulic Turbine Performance
Draft tube of Francis type hydraulic turbine usually consists of: cone, elbow and diffuser. On the contrary, in some power stations an extra pipe should be added to the draft tube at the bottom of cone because of installation limitation. In this paper, this special case has been numerically studied. To this end CFD analysis was applied to simulate all parts of hydraulic turbine. A homogeneous m...
متن کاملOptimal control for load alleviation in wind turbines
Nowadays, trailing edge flaps on wind turbine blades are considered to reduce loading stresses in wind turbine components. In this paper, an optimal control synthesis methodology for the design of gust load controllers for large wind turbine blades is proposed. We discuss a control synthesis approach that minimises the power expenditure of the actuated trailing edge flap, while at the same time...
متن کامل