Investigation of Initial Implant Stability with Different Dental Implant Designs. A Pilot Study in Pig Ribs Using Resonance Frequency Analysis
نویسندگان
چکیده
Linish Vidyasagar B.D.S., MSc (Helsinki), Dip. Prosth., Department of Prosthodontics, Faculty of Dentistry, Riga Stradina University, Riga, Latvia. Girts Salms M.D., D.D.S., Lecturer at Department of Oral and Maxillofacial Surgery, Faculty of Dentistry, Riga Stradina University, Riga, Latvia. Peteris Apse D.D.S., MSc (Toronto), Dr. habil med. (Latvia), professor, Department of Prosthodontics, Faculty of Dentistry, Riga Stradina University,Riga, Latvia. Uldis Teibe Dr.Biol., Assoc.Prof., Department of Prosthodontics, Faculty of Dentistry, Riga Stradina University, Riga, Latvia.
منابع مشابه
Resonance frequency analysis of implant stability in augmented and non-augmented sinus sites
Background and aim: Although there have been substantial developments in dental implant therapies, achieving good implant stability (ISQ >60) for implants inserted in augmented sinus sites appears to be challenging in comparison with non-augmented sites due to the high prevalence of bone resorption in posterior regions of maxilla. This study aimed to evaluate and compare the time required to a...
متن کاملThe Influence of Site Preparation (Countersinking) on Initial Dental Implant Stability. An in vitro Study Using Resonance Frequency Analysis
Primary implant stability is considered to be a critical factor for obtaining successful osseointegration [1]. Studies using Resonance Frequency Analysis (RFA) have demonstrated that initial implant stability is determined by the density of the bone, the surgical technique used, and the design of the implant [2, 3]. While different implant designs have shown similar results of higher stabilitie...
متن کاملStress Distribution in Natural Tooth and Implant Supported Removable Partial Denture with Different Attachment Types: A Photoelastic Analysis
Background and Aim: Different attachment designs have been developed to connect implant to natural teeth in partial dentures; however, adequate studies have not been performed to determine stress distribution patterns in these designs. The present study aimed to assess stress distribution patterns in natural tooth and implant supported removable partial denture with different attachment designs...
متن کاملComparative evaluation of the stability of two different dental implant designs and surgical protocols—a pilot study
BACKGROUND The purpose of this study was to compare a parallel wall design implant to a tapered apex design implant when placed in the posterior maxilla using two different surgical protocols. METHODS Twenty-seven patients (30 implants) were divided into three groups. All implants were 4 mm wide in diameter and 8 mm long. Group A received 10 tapered implants (OSPTX) (Astra Tech OsseoSpeed TX™...
متن کاملFinite Element Analysis of Different Hip Implant Designs along with Femur under Static Loading Conditions
Background: The hip joint is the largest joint after the knee, which gives stability to the whole human structure. The hip joint consists of a femoral head which articulates with the acetabulum. Due to age and wear between the joints, these joints need to be replaced with implants which can function just as a natural joint. Since the early 19th century, the hip joint arthroplasty has evolved, a...
متن کامل