RFC 5077 Stateless
نویسندگان
چکیده
Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract This document describes a mechanism that enables the Transport Layer Security (TLS) server to resume sessions and avoid keeping per-client session state. The TLS server encapsulates the session state into a ticket and forwards it to the client. The client can subsequently resume a session using the obtained ticket. This document obsoletes RFC 4507.
منابع مشابه
Internet Engineering Task Force (ietf) 464xlat: Combination of Stateful and Stateless Translation
This document describes an architecture (464XLAT) for providing limited IPv4 connectivity across an IPv6-only network by combining existing and well-known stateful protocol translation (as described in RFC 6146) in the core and stateless protocol translation (as described in RFC 6145) at the edge. 464XLAT is a simple and scalable technique to quickly deploy limited IPv4 access service to IPv6-o...
متن کاملRFC 4507 Stateless TLS Session
This document describes a mechanism that enables the Transport Layer Security (TLS) server to resume sessions and avoid keeping per-client session state. The TLS server encapsulates the session state into a ticket and forwards it to the client. The client can subsequently resume a session using the obtained ticket. Salowey, et al. Standards Track [Page 1] RFC 4507 Stateless TLS Session Resumpti...
متن کاملRenumbering Requirements for Stateless Dynamic Host Configuration Protocol for IPv6 (DHCPv6)
IPv6 hosts using Stateless Address Autoconfiguration are able to configure their IPv6 address and default router settings automatically. However, further settings are not available. If these hosts wish to configure their DNS, NTP, or other specific settings automatically, the stateless variant of the Dynamic Host Configuration Protocol for IPv6 (DHCPv6) could be used. This combination of Statel...
متن کاملPrivacy Extensions for Stateless Address Autoconfiguration in IPv6
Stateless address autoconfiguration defines the mechanism for a IPv6 node to generate an address without the need of an external DHCP server based on the interface identifier. In the case of Ethernet the Interface Identifier is based on the EUI-64 identifier derived from the interface’s built-in 48-bit IEEE 802 address (MAC address). The IPv6 address generated via Stateless Autoconfiguration co...
متن کاملRFC 7600 Stateless IPv
This document specifies a stateless solution for service providers to progressively deploy IPv6-only network domains while still offering IPv4 service to customers. The solution’s distinctive properties are that TCP/UDP IPv4 packets are valid TCP/UDP IPv6 packets during domain traversal and that IPv4 fragmentation rules are fully preserved end to end. Each customer can be assigned one public IP...
متن کامل