Diagnosing Resistive Bridges Using Adaptive Techniques
نویسندگان
چکیده
A systematic procedure for locating resistive bridges is presented. Critical path tracing is used to identify a set of “suspect” bridges whose presence could explain all of the observed faulty behavior of the circuit for the original test set. The set of suspects is then reduced by adaptively applying additional tests derived from the failing vector pairs in the original test set. Unlike other approaches, the approach presented here is not based on any bridge fault modeling and does not require any fault simulation.
منابع مشابه
Real-time damage detection of bridges using adaptive time-frequency analysis and ANN
Although traditional signal-based structural health monitoring algorithms have been successfully employed for small structures, their application for large and complex bridges has been challenging due to non-stationary signal characteristics with a high level of noise. In this paper, a promising damage detection algorithm is proposed by incorporation of adaptive signal processing and Artificial...
متن کاملAn Optimal Design Approach for Resistive and Inductive Superconducting Fault Current Limiters via MCDM Techniques
The design process of a superconducting current limiter (SFCL) requires simulation and definition of its electrical, magnetic and thermal properties in form of equivalent circuits and mathematical models. However, any change in SFCL parameters: dimension, resistance, and operating temperature can affect the limiting mode, quench time, and restore time. In this paper, following the simulation of...
متن کاملAnalysis of delay caused by Resistive Bridging faults in Secured CMOS 45 nm Technology, Implemented in QDI GHANIA AIT ABDELMALEK, REZKI ZIANI and MOURAD LAGHROUCHE
The article focuses on the defects modeling of secured CMOS circuits, implemented in Quasi Delay Insensitive (QDI). We analyze the static and the dynamic behavior of resistive bridges as a function of its unpredictable resistance. SPICE simulations were performed for 45nm CMOS technology. Simulation results are given for the conditions of defect detection and for the delay induced by the resist...
متن کاملPerformance Improvement of Expanded Integrated Local Area Networks (RESEARCH NOTE)
In Local Area Networks (LAN) connected together by bridges, flow control and smooth traffic in the network is very important. However, congestion at bridges can cause intensive loss of received frames. In addition, the received frames are thrown away and have to be retransmitted by the source station, which causes more congestion and massive reduction in the overall network throughput. The netw...
متن کاملInaccuracies of Anisotropic Magneto- Resistance Angle Sensors Due to Assembly Tolerances
A large class of angle sensors uses a small permanent magnet attached to the rotor. The magnet is polarized perpendicularly to the axis of rotation, and a magnetic field sensor is placed ahead on the axis. The sensor circuit consists of two full bridges at 45◦, each having four anisotropic magneto-resistive (AMR) elements. Even though the electronic system may be calibrated to have nearly no er...
متن کامل