Study on Energy Efficiency of Water Hydraulic Fluid Switching Transmission
نویسندگان
چکیده
Water hydraulic fluid switching transmission (FST) has lower environmental load and lower energy loss in valves for using only ON/OFF valves. In addition, improvement of transmission efficiency can be expected by using accumulator as the second driving source and making use of waste energy by energy recovering action. This paper concerned with experimental results and a design of simulator of the FST system. First, it was shown from experimental results that the error rate was within 5 percent and the recovered energy during the deceleration phase was more than 25-38% of the kinetic energy of the load. Next, the FST simulator was developed for designing the key parameters to achieve higher transmission efficiency. As a result, the effects of design parameters of FST system were clarified and design standard of water hydraulic FST was established.
منابع مشابه
Transmission switching cost modeling and determination candidate Lines for participation in joint energy and reserve markets
There is a great resolution calling for smart grids in recent years. Introduction of new technologies, that make the network flexible and controllable, is a main part of smart grid concept and a key factor to its success. Transmission network as a part of system network has drawn less attention. Transmission switching as a transmission service can release us from load shedding and remove the co...
متن کاملCharacteristics of S-jump on Roughened Bed Stilling Basin
Formation of hydraulic jump is necessary for dissipation of the excess kinetic energy downstream of spillways and gates. Hydraulic jump stilling basins of sudden expansion are one of the energy dissipater structures which are used where the available tail water depth is less than the required sequent depths. In the present study to further reduce the hydraulic jump sequent depths ratio, a rough...
متن کاملOn Fluid Compressibility in Switch-Mode Hydraulic Circuits - Part I: Modeling and Analysis
Fluid compressibility has a major influence on the efficiency of switch-mode hydraulic circuits due to the release of energy stored in fluid compression during each switching cycle and the increased flow rate through the high-speed valve during transition events. Multiple models existing in the literature for fluid bulk modulus, the inverse of the compressibility, are reviewed and compared with...
متن کاملImprovement of Overall Efficiency in the Gas Transmission Networks: Employing Energy Recovery Systems
This study mainly focuses on enhancing the overall efficiency of gas transmission networks. The authors developed a model with detailed characteristics of compressor and pressure reduction stations. Following this, they suggested three different systems with gas turbine including: organic rankine cycle (ORC), air bottoming cycle (ABC), and ABC along with steam injection (SI-ABC). In addition, u...
متن کاملEnhancement in energy and exergy efficiency of a solar receiver using suspended alumina nanparticles (nanofluid) as heat transfer fluid
An experimental and theoretical energy and exergy analysis was conducted for a cylindrical cavity receiver employed in a parabolic dish collector. Based on simultaneous energy and exergy analysis, the receiver average wall temperature and overall heat transfer coefficient were determined. A simplified Nusselt number for Heat Transfer Fluid (HTF) through the receiver as a function of Reynolds an...
متن کامل