Microparticle collection and concentration via a miniature surface acoustic wave device.
نویسندگان
چکیده
The ability to detect microbes, pollens and other microparticles is a critically important ability given the increasing risk of bioterrorism and emergence of antibiotic-resistant bacteria. The efficient collection of microparticles via a liquid water droplet moved by a surface acoustic wave (SAW) device is demonstrated in this study. A fluidic track patterned on the SAW device directs the water droplet's motion, and fluid streaming induced inside the droplet as it moves along is a key advantage over other particle collection approaches, because it enhances microparticle collection and concentration. Test particles consisted of 2, 10, 12 and 45 microm diameter monodisperse polystyrene and melamine microparticles; pollen from the Populus deltoides, Kochia scoparia, Secale cerale, and Broussonetia papyrifera (Paper Mulberry) species; and Escherichia coli bacteria. The collection efficiency for the synthetic particles ranged from 16 to 55%, depending on the particle size and surface tension of the collection fluid. The method was more effective in collecting pollen and the bacteria with an efficiency of 45-68% and 61.0-69.8%, respectively. Pollen collection was strongly influenced by its diameter, size, and surface geometry in a manner contrary to initial expectations. Reasons for the consistent yet unexpected collection results include leaky SAW pressure boundary segregation and shear-induced concentration of larger particles, and the subtle effects of wetting interactions. These results demonstrate a new method for collecting microparticles requiring only about one second per run, and illustrate the inadequacy of using synthetic microparticles as a substitute for their biological counterparts in experiments studying particle collection and behavior.
منابع مشابه
TiO2 based surface acoustic wave gas sensor with modified electrode dimensions for enhanced H2 sensing application
The design and optimization of nanostructure-based surface acoustic wave (SAW) gas sensor is analyzed based on TiO2 sensing layer and modified electrode dimensions. The sensitivity of the gas sensor depends upon the type of sensing layer used and active surface area obtained by varying the aspect ratio. The performance of the sensor is observed from 0.1ppm to 100ppm concentration of ...
متن کاملExploitation of surface acoustic waves to drive size-dependent microparticle concentration within a droplet.
Ultrafast particle and cell concentration is essential to the success of subsequent analytical procedures and the development of miniaturized biological and chemical sensors. Here, surface acoustic wave (SAW) devices were used to excite a MHz-order acoustic wave that propagates into a microlitre droplet to drive spatial concentration and separation of two different sized suspended microparticle...
متن کاملSurface acoustic wave concentration of microparticle and nanoparticle suspensions
A rapid particle concentration method in a sessile droplet has been developed using asymmetric surface acoustic wave (SAW) propagation on a substrate upon which the droplet is placed. The SAW device consisted of a 0.75-mm thick, 127.68 YXaxis-rotated cut LiNbO3 as a substrate. An interdigital transducer electrode (IDT) with 25 straight finger pairs in a simple repeating pattern, 12 mm aperture,...
متن کاملSurface Acoustic Waves: a New Paradigm for Driving Ultrafast Biomicrofluidics
Surface acoustic waves (SAWs), which are 10 MHz order surface waves roughly 10 nm in amplitude propagating on the surface of a piezoelectric substrate, can offer a powerful method for driving fast microfluidic actuation and microparticle or biomolecule manipulation. We demonstrate that sessile drops can be linearly translated on planar substrates or fluid can be pumped through microchannels at ...
متن کاملElastomeric negative acoustic contrast particles for affinity capture assays.
This report describes the development of elastomeric capture microparticles (ECμPs) and their use with acoustophoretic separation to perform microparticle assays via flow cytometry.We have developed simple methods to form ECμPs by cross-linking droplets of common commercially available silicone precursors in suspension followed by surface functionalization with biomolecular recognition reagents...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Lab on a chip
دوره 7 5 شماره
صفحات -
تاریخ انتشار 2007