Pool boiling heat transfer enhancement over cylindrical tubes with water at atmospheric pressure, Part II: Experimental results and bubble dynamics for circumferential V-groove and axial rectangular open microchannels

نویسندگان

  • Jeet S. Mehta
  • Satish G. Kandlikar
چکیده

A two-part experimental study is conducted on pool boiling heat transfer over enhanced cylindrical microchannel test surfaces with water at atmospheric pressure. In this Part II of the study, the effects of circumferential V-groove microchannels and axial rectangular microchannels are reported. These experiments were performed in the horizontal as well as vertical orientations. The heat transfer performances of the modified surfaces are compared with that of a plain surface. At a heat flux of 1070 kW/m a maximum heat transfer coefficient of 96 kW/m K was achieved with an axial rectangular microchannel test section in the vertical orientation. Videos captured using a high speed camera were analyzed and the boiling heat transfer mechanisms seen at low and medium heat flux conditions were discussed. The enhancement in the heat transfer performance, and the improvement of the critical heat flux observed with these modified test sections have been attributed to the liquid rewetting phenomenon of the heated surfaces through the microchannels. 2013 Elsevier Ltd. All rights reserved.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Two Phase Heat Transfer Characteristics in a Vertical Small Diameter Tube at Sub Atmospheric Pressure

Two-phase heat transfer is experimentally examined through vertical small diameter tubes, D =1.45 and 2.8 mm using water under a pressure of 50 to 81 kPa and a natural circulation condition. The pool boiling correlation by Stephan-Abdelsalam and the thermosyphon boiling correlation by Imura, et al. predict the measured experimental data in the 2.8 mm tube with an error of -30%. A large heat tra...

متن کامل

Pool Boiling Heat Transfer and Bubble Dynamics Over Plain and Enhanced Microchannels

Pool boiling is of interest in high heat flux applications because of its potential for removing large amount of heat resulting from the latent heat of evaporation and little pressure drop penalty for circulating coolant through the system. However, the heat transfer performance of pool boiling systems is not adequate to match the cooling ability provided by enhanced microchannels operating und...

متن کامل

Pool Boiling Heat Transfer in Water/Amines Solutions

In this investigation, nucleate boiling heat transfer coefficients were experimentally measured during pool boiling of mixtures, consisting of water/monoethanolamine and water/diethanolamine on a horizontal heating rod, under atmospheric pressure. The experiment was carried out below 205 kW.m-2 heat flux, over a wide range of concentrations. These experiments include, measurement of pool boilin...

متن کامل

Effect of open microchannel geometry on pool boiling enhancement

Pool boiling enhancement through surface modification has garnered the attention of many researchers for extending the limits of heat flux dissipation. Simulated copper chips were used in a pool boiling setup with water boiling at atmospheric pressure. Heat transfer performance of different microchanneled surfaces was compared to that of a plain surface. The results of the study showed that the...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013