Thick-film Actuation Technologies for Mems Applications
نویسندگان
چکیده
⎯ This paper compares two thick-film actuation technologies and assesses their suitability for use within micromachined devices. The materials are a piezoelectric composition, which exhibits a d33 coefficient of the order of 130pC/N, and a magnetostrictive material which possess a magnetostriction of 4.4ppm at a magnetic field of 11.5kA/m. Examples of their application in micromachined devices are also given.
منابع مشابه
Design and simulation of a RF MEMS shunt capacitive switch with low actuation voltage, low loss and high isolation
According to contact type, RF MEMS switches are generally classified into two categories: Capacitive switches and Metal-to-Metal ones. The capacitive switches are capable to tolerate a higher frequency range and more power than M-to-M switches. This paper presents a cantilever shunt capacitive RF MEMS switch with characteristics such as low trigger voltage, high capacitive ratio, short switchin...
متن کاملPiezoelectric versus electrostatic actuation for a capacitive RF-MEMS switch
-In this paper, piezoelectric actuation is compared with electrostatic actuation for application in RF-MEMS switches with respect to actuation voltage and technological implementation. The expression for the actuation voltages of electrostatic and piezoelectric actuation are discussed and compared with respect to scaling. Calculation examples show actuation voltages for a cantilever beam of 1μm...
متن کاملA Pzt Multilayer Thick-film Actuator for Ultrasonic Applications
In many MEMS applications there is a requirement for actuating a structure. This paper describes a method of generating acoustic power from a PZT based thick-film structure which gives output power and electrical efficiencies at least as good as, and in some cases better than bulk PZT in the same application.
متن کاملNanotube micro-opto-mechanical systems
While there have been numerous reports on the electromechanical actuation of carbon nanotubes (CNTs), devices based on the photomechanical actuation of CNTs have been elusive until now. In this paper, we report the integration of single-wall carbon nanotube ensembles into micro-mechanical systems to realize a new carbon nanotube micro-opto-mechanical system (CNT-MOMS). CNT-MOM grippers were fab...
متن کاملResponse of Mems Devices under Shock Loads
There is strong experimental evidence for the existence of strange modes of failure of MEMS devices under shock. Such failures have not been explained with conventional models of MEMS. These failures are characterized by overlaps between moving microstructures and stationary electrodes, which cause electrical shorts. This work presents a model and simulation of MEMS devices under the combinatio...
متن کامل