Twenty-Eight Orders of Parametric Resonance in a Microelectromechanical Device for Multi-band Vibration Energy Harvesting
نویسندگان
چکیده
This paper contends to be the first to report the experimental observation of up to 28 orders of parametric resonance, which has thus far only been envisioned in the theoretical realm. While theory has long predicted the onset of n orders of parametric resonance, previously reported experimental observations have been limited up to about the first 5 orders. This is due to the rapid narrowing nature of the frequency bandwidth of the higher instability intervals, making practical accessibility increasingly more difficult. Here, the authors have experimentally confirmed up to 28 orders of parametric resonance in a micromachined membrane resonator when electrically undamped. While the implication of this finding spans across the vibration dynamics and transducer application spectrum, the particular significance of this work is to broaden the accumulative operational frequency bandwidth of vibration energy harvesting for enabling self-powered microsystems. Up to 5 orders were recorded when driven at 1.0 g of acceleration across a matched load of 70 kΩ. With a natural frequency of 980 Hz, the fundamental mode direct resonance had a -3 dB bandwidth of 55 Hz, in contrast to the 314 Hz for the first order parametric resonance; furthermore, the half power bands of all 5 orders accumulated to 478 Hz.
منابع مشابه
A periodic folded piezoelectric beam for efficient vibration energy harvesting
Periodic piezoelectric beams have been used for broadband vibration energy harvesting in recent years. In this paper, a periodic folded piezoelectric beam (PFPB) is introduced. The PFPB has special features that distinguish it from other periodic piezoelectric beams. The Adomian decomposition method (ADM) is used to calculate the first two band gaps andtwelve natural frequencies of the PF...
متن کاملShape Design Optimization of Unimorph Piezoelectric Cantilever Energy Harvester
The most promising method for micro scale energy scavenging is via vibration energy harvesting which converts mechanical energy to electrical energy. Using piezoelectric cantilevers is the most common method for vibration energy harvesting. Changing the shape of the cantilevers can lead to changing the generated output voltage and power. In this work vibration energy harvesting via piezoelectri...
متن کاملUltra-broadband electromagnetic MEMS vibration energy harvesting
This paper presents the design, fabrication and characterization of an electromagnetic MEMS energy harvester with ultra-broad operating bandwidth. The beam stretching induced nonlinear spring stiffness enables the resonance to extend from 65 Hz to 340 Hz and 400 Hz at accelerations of 0.5g and 1.0g, respectively. The ultra-wide bandwidth could benefit the harvester device for more efficient vib...
متن کاملPiezoelectric Generators for Vibrational Energy Harvesting
In past times, energy harvesting used piezoelectric materials was very popular for new research. The devices shapes sizes and dimensions was tested, but was difficult to match power measurement as a device fabrication and other method which vary from paper to paper. In an standard comparison by changing the parameters , the dependence of on device dimension has been investigated. The devices li...
متن کاملAn Electromagnetic MEMS Energy Harvester Array with Multiple Vibration Modes
This paper reports the design, micromachining and characterization of an array of electromagnetic energy harvesters (EHs) with multiple frequency peaks. The authors present the combination of three multi-modal spring-mass structures so as to realize at least nine resonant peaks within a single microelectromechanical systems (MEMS) chip. It is assembled with permanent magnet to show an electroma...
متن کامل