comparison of phenol removal in anaerobic fluidized bed reactors with sand and gac media

Experimental and Theoretical Investigation of Anaerobic Fluidized Bed Biofilm Reactors

This work presents an experimental and theoretical investigation of anaerobic fluidized bed reactors (AFBRs). The bioreactors are modeled as dynamic three-phase systems. Biochemical transformations are assumed to occur only in the fluidized bed zone. The biofilm process model is coupled to the system hydrodynamic model through the biofilm detachment rate; which is assumed to be a first-order fu...

Phenol Degradation in an Anaerobic Fluidized Bed Reactor Packed with Low Density Support Materials

The objective of this research was to study phenol degradation in anaerobic fluidized bed reactors (AFBR) packed with polymeric particulate supports (polystyrene PS, polyethylene terephthalate – PET, and polyvinyl chloride PVC). The reactors were operated with a hydraulic retention time (HRT) of 24 h. The influent phenol concentration in the AFBR varied from 100 to 400 mg L, resulting in phenol...

24 Fixed Film Stationary Bed and Fluidized Bed Reactors

GASIFICATION vs COMBUSTION OF WASTE/BIOMASS IN FLUIDIZED BED REACTORS

This paper presents a comparison of commercial fluidized bed gasifiers and combustors used to recover energy from municipal solid wastes and biomass. The work reported here is excerpted from four case studies prepared for the International Energy Agency’s Bioenergy Agreement, under Task 23 (Energy from Thermal Conversion of MSW and RDF, 1998-2000) and Task 36 (Energy from Integrated Solid Waste...

Modeling of Non-isothermal Reacting Flow in Fluidized Bed Reactors

Abstract: We investigate a prototype concept of a back-up electricity device where we use liquid formic acid (FA) to produce a mixture of carbon dioxide (CO2) and hydrogen (H2) which is used in a PEM fuel cell, Fig. 1. In the fluidized bed reactor the liquid FA is decomposed to a gaseous mixture of CO2 and H2 in the presence of microscopic floating solid catalytic particles. We describe the sys...

Early Detection of Agglomeration in Fluidized Bed Polymerisation Reactors

Polyethylene (PE) and polypropylene (PP) make up for a large part of the total worldwide polymer production. Originally, both polymers were often produced in solution processes. However, fluidized bed reactors for polyethylene and polypropylene production gain increasing industrial interest because of the relatively low production costs, the ability to produce a wide range of polymer grades, an...