XXXIX.—The freezing points of alloys containing zinc and another metal
نویسندگان
چکیده
منابع مشابه
On DTA Curves for the Melting and Freezing of Alloys
Using a heat flow model of a DTA (differential thermal analyzer) and thermal characteristics obtained by fitting experimental results for a pure metal, the response of the DTA is modeled for the melting and solidification of alloys. The enthalpy-temperature relation used for the alloy simulations is obtained by two different methods: 1) equilibrium and Scheil considerations derived solely from ...
متن کاملMelting and freezing of metal clusters.
Recent developments allow heat capacities to be measured for size-selected clusters isolated in the gas phase. For clusters with tens to hundreds of atoms, the heat capacities determined as a function of temperature usually have a single peak attributed to a melting transition. The melting temperatures and latent heats show large size-dependent fluctuations. In some cases, the melting temperatu...
متن کاملMagnetically driven three-dimensional manipulation and inductive heating of magnetic-dispersion containing metal alloys.
Fundamental to the development of three-dimensional microelectronic fabrication is a material that enables vertical geometries. Here we show low-melting-point metal alloys containing iron dispersions that can be remotely manipulated by magnetic fields to create vertical geometries and thus enable novel three-dimensional assemblies. These iron dispersions enhance the mechanical properties needed...
متن کاملZinc-Nickel Binary Alloys Electrodeposition of Steel Using Pulse Current
Zinc-Nickel electrodeposits have been widely adopted for surface treatment of automobile steel sheet for high corrosion resistance. In this work the effect of pulse parameters on the Zn-Ni alloy electrodeposits was investigated. The hardness, thickness, corrosion resistance and composition of deposits thus produced were investigated. The surface topography of the deposits was also observed in S...
متن کاملFreezing Points of Anti-coagulant Salt Solutions
By a method involving equilibration of ice and solution, and analysis of the solution, freezing point depressions of solutions of sodium citrate, oxalate, and fluoride have been determined over the range Delta = 0.45 to 0.65 degrees C. Determinations with sodium chloride solutions have confirmed the accuracy of the method. In each case the freezing point depression is given, within 0.002 degree...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: J. Chem. Soc., Trans.
سال: 1897
ISSN: 0368-1645
DOI: 10.1039/ct8977100383