Validation of Virtual Flux Method for Forced Convection Flows
نویسندگان
چکیده
منابع مشابه
semi-analytical solution for static and forced vibration problems of laminated beams through smooth fundamental functions method
در این پایان نامه روش جدیدی مبتنی بر روش حل معادلات دیفرانسیل پارهای بر اساس روش توابع پایه برای حل مسایل ارتعاش اجباری واستاتیک تیرها و صفحات لایه ای ارایه شده است که می توان تفاوت این روش با روش های متداول توابع پایه را در استفاده از توابع هموار در ارضاء معادلات حاکم و شرایط مرزی دانست. در روش ارایه شده در این پایاننامه از معادله تعادل به عنوان معادله حاکم بر رفتار سیستم استفاده شده است که مو...
15 صفحه اولNanofluid forced convection through a microtube with constant heat flux and slip boundary
Given the need to increase the efficiency of heat transfer in thermal systems, especially systems using nanofluids in microscale and nanoscale heat transfer equipment ideas to improve their performance is very good.In present study, the flow and heat transfer of Water-Cu nanofluid in micro-tube with slip regime with constant wall heat flux numerically simulated with low Reynolds numbers. Sl...
متن کاملThe flux integral method for multidimensional convection and diffusion
The jlux integral method is a procedure for constructing an explicit single-step forward-in-time conservative control-volume update of the unsteady multidimensional convection-d@usion equation. The convective-plusdifjiiveJlux at each face of a control-volume cell is estimated by integrating the transported variable and its face-normal derivative over the volume swept out by the convecting veloc...
متن کاملBurnout in Forced Convection
Data are presented for burnout in forced coivection nucleate boiling of water at pressures above 500 psia. A dimensionless correlation is devised for. the M.I.T. data which is found to be valid for certain recent data reported by Argonne National Laboratory.
متن کاملForced-convection boiling and critical heat flux from a linear array of discrete heat sources
Forced-convection boiling experiments were performed with FC-72, a 3M Fluorinert, at 1.36 bar on a linear array of nine discrete heat sources simulating microelectronic chips, which were flushmounted in a vertical. rectangular channel. The inlet velocity and liquid subcooling were varied from 13 to 400 cm s’ and 3 to 36”C, respectively. Special design of the experimental apparatus allowed each ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 2006
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.72.217