Using multiple performance characteristics to optimize the percent zinc coating balances edge joints of galvanized steel sheets for metal inert gas pulse brazing process
نویسندگان
چکیده
منابع مشابه
Copper coating of carbon steel by a furnace brazing process using brass as the braze
A ship building grade of carbon steel has been coated with copper by a furnace brazing process starting from a brass braze. An argon protective atmosphere was used to prevent oxidation of the steel. However, when the deposit was produced a low gas flow rate ensured that zinc was lost from the brass by oxidation leaving a copper deposit on the steel surface. The copper was found to be zinc free ...
متن کاملDetermination of the Forming Limit Diagram of Zinc Electro-galvanized Steel Sheets
Forming limit curves (FLC) of deep drawing steel sheets have been determined experimentally and calculated on the base of the material tensile properties following the Hill, Swift, Marciniak-Kuczyński and Sing-Rao methods. Only the FLC modeled from a singly linear forming limit stress curve exhibits good consistence with experimental curve. It was established that a linearized limit stress locu...
متن کاملInfluence of the Manufacturing Process on Defects in the Galvanized Coating of High Carbon Steel Wires
This study is a detailed failure analysis of galvanized high carbon steel wires, which developed coating cracks during the torsion test performed as a quality control at the end of the manufacturing process. Careful visual inspections showed that the cracks are already present in the coating before the torsion test. In order to explain the origin of these cracks, systematic metallographic inves...
متن کاملEvaluation Of Mechanical Properties Of Dissimilar Metal Tube Welded Joints Using Inert Gas Welding
Evaluation of welding process such as metal inert gas welding and tungsten inert gas arc welding on tensile, bend and hardness properties of austenitic stainless steel SS347H(18Cr 10Ni 1Cb ), T22(21⁄4Cr Mo) and T91(9Cr 1Mo V) grades are studied. Tubes of 54 mm of outer diameter and 4 mm of wall thickness is used as a base material in the following combination SS347H VS T91 and T91 VS T22 is wel...
متن کاملconsequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir
there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...
ذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Mechanical Engineering
سال: 2017
ISSN: 1687-8140,1687-8140
DOI: 10.1177/1687814017714983