Using heat pipes to improve the efficiency of gas-dynamic thermal stratification
نویسندگان
چکیده
منابع مشابه
assessment of the efficiency of s.p.g.c refineries using network dea
data envelopment analysis (dea) is a powerful tool for measuring relative efficiency of organizational units referred to as decision making units (dmus). in most cases dmus have network structures with internal linking activities. traditional dea models, however, consider dmus as black boxes with no regard to their linking activities and therefore do not provide decision makers with the reasons...
Thermal performance of flat-shaped heat pipes using nanofluids
0017-9310/$ see front matter 2009 Elsevier Ltd. A doi:10.1016/j.ijheatmasstransfer.2009.12.007 * Corresponding author. E-mail address: [email protected] (K. Vafai). Analytical models are utilized to investigate the thermal performance of rectangular and disk-shaped heat pipes using nanofluids. The liquid pressure, liquid velocity profile, temperature distribution of the heat pipe wall, tempera...
متن کاملThermal performance of TAPS heat pipes with non-condensable gas blockage
Over 124,300 heat pipes were installed in vertical support members on the Trans Alaska Pipeline System. Infrared surveys in the early 1980s revealed cold topping on some of these heat pipes. The cold topping was due to an accumulation of non-condensable gases, a by-product of corrosion or chemical dissociation of anhydrous ammonia. In 2000, Alyeska Pipeline Service Company undertook an experime...
متن کاملhazard evaluation of gas condensate stabilization and dehydration unit of parsian gas refinery using hazop procedures
شناسایی مخاطرات در واحد 400 پالایشگاه گاز پارسیان. در این پروزه با بکارگیری از تکنیک hazop به شناسا یی مخاطرات ، انحرافات ممکن و در صورت لزوم ارایه راهکارهای مناسب جهت افزایش ایمنی فرا یند پرداخته میگردد. شرایط عملیاتی مخاطره آمیز نظیر فشار و دمای بالا و وجود ترکیبات مختلف سمی و قابل انفجار در واحدهای پالایش گاز، ضرورت توجه به موارد ایمنی در این چنین واحدهایی را مشخص می سازد. مطالعه hazop یک ر...
Using Experimental Procedure to Improve the Efficiency of the Two Stand Reversing Cold Mill
Production of thin steel strips with 0.18-0.26 mm thickness is about 0.75 of annual production of the two stand reversing cold mill, while its efficiency is 60%. This is due to the fact that after montaging the grinded work rolls, rolling thin steel strips (with thicknesses less than 0.18 millimeters) is unavailable. Initially, unsuitable surface roughness, the friction between rolls and the st...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: VESTNIK of the Samara State Aerospace University
سال: 2013
ISSN: 2541-7533,2542-0453
DOI: 10.18287/1998-6629-2013-0-3-2(41)-192-197