Upper-bound limit analysis of soils with a nonlinear failure criterion
نویسندگان
چکیده
منابع مشابه
Lower Bound Limit Analysis Using Nonlinear Programming
This paper describes a general numerical formulation of the lower bound theorem of classical plasticity. The method is based on simplex finite elements and nonlinear programming and is applicable to problems in one, two and three dimensions. The use of linear finite elements guarantees that the computed collapse loads are, within computational accuracy, rigorous lower bounds on the true collaps...
متن کاملSlope Stability Analysis Using Limit Equilibrium Method in Nonlinear Criterion
In slope stability analysis, the limit equilibrium method is usually used to calculate the safety factor of slope based on Mohr-Coulomb criterion. However, Mohr-Coulomb criterion is restricted to the description of rock mass. To overcome its shortcomings, this paper combined Hoek-Brown criterion and limit equilibrium method and proposed an equation for calculating the safety factor of slope wit...
متن کاملAn Upper Bound Analysis of Sandwich Sheet Rolling Process
In this research, flat rolling process of bonded sandwich sheets is investigated by the method of upper bound. A kinematically admissible velocity field is developed for a single layer sheet and is extended into the rolling of the symmetrical sandwich sheets. The internal, shear and frictional power terms are derived and they are used in the upper bound model. Through the analysis, the rolling ...
متن کاملAn Upper Bound Solution for Analysis of Twist Extrusion Process with Elliptical Die Cross-section
Twist extrusion process is a rather new route to produce highly strained materials. In this process, severe plastic deformation is applied by large shear strains. In current article, required energy for twist extrusion by use of admissible velocity field together with the upper bound technique is predicted. The proposed model is capable of considering the effect of various parameters such as di...
متن کاملUpper Bound Analysis of Tube Extrusion Process Through Rotating Conical Dies with Large Mandrel Radius
In this paper, an upper bound approach is used to analyze the tube extrusion process through rotating conical dies with large mandrel radius. The material under deformation in the die and inside the container is divided to four deformation zones. A velocity field for each deformation zone is developed to evaluate the internal powers and the powers dissipated on all frictional and velocity disco...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Canadian Geotechnical Journal
سال: 2020
ISSN: 0008-3674,1208-6010
DOI: 10.1139/cgj-2018-0513