UNSTABLE TEARING FRACTURE OF SHEET SPECIMENS UNDER MODE II LOADING
نویسندگان
چکیده
منابع مشابه
Dynamic fracture initiation in brittle materials under combined mode I/II loading
A new test method has been developed to measure the resistance of dynamic fracture initiation in brittle materials under combined mode I/I loadings. The Brazilian disks with center-cracks have been fractured under oblique impact loadings in diarnetral-compression. The dynamic stress intensity factors of mode I and H are evaluated from the superposition integrals of the step response functions f...
متن کاملFinite Element Modeling of Crack Initiation Angle Under Mixed Mode (I/II) Fracture
Present study deals with the prediction of crack initiation angle for mixed mode (I/II) fracture using finite element techniques and J-Integral based approach. The FE code ANSYS is used to estimate the stress intensity factor numerically. The estimated values of SIF were incorporated into six different crack initiation angle criteria to predict the crack initiation angle. Single edge crack spec...
متن کاملThe Effect of Inclined U-Notch Geometry on Mode Ratio (KII/KI) under Mixed Mode (I + II) Loading
In inclined U-notches, the mixed mode (I + II) loading occurs and the mode ratio can be increased by varying the notch angle. In this paper, the effect of the inclined U-notch geometry, i.e. the notch depth, the notch angle, the notch root radius, and the position of the notch with respect to supports, on the mode ratio (KII/KI) have been studied. Three-point bending and plane strain condition ...
متن کاملPrediction of Mode II of Fracture Toughness in Laminate Composites
In this paper, effects of ply orientation of adjacent plies with (ϕ//θ) interfaces on mode II critical strain energy release rate (fracture toughness) of multidirectional (MD) laminate has been studied. Ply orientation of adjacent plies is one of the most important parameters affects the mode II critical strain energy release rate () in the initiation of the delamination. To study this paramet...
متن کاملMixed mode stable tearing of thin sheet Al 6061-T6 specimens: experimental measurements and finite element simulations using a modified Mohr-Coulomb fracture criterion
In this investigation, a combined experimental and computational approach with a Modified Mohr Coulomb (MMC) fracture criterion employing post-initiation element softening is used to simulate stable crack propagation under Mode I, Mode III and combined Mode I/III loading conditions. Results from the studies demonstrate that good correlation exists between the measured load-displacement and the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1985
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.28.1825