Ultrasonic Assisted Milling of Reinforced Plastics
نویسندگان
چکیده
منابع مشابه
Effect of chisel edge in ultrasonic assisted drilling of carbon fibre reinforced plastics (CFRP)
Ultrasonic assisted drilling (UAD) has been reported effective for thrust force reduction during drilling of CFRP resulting in lower exit delamination. However, this process is not fully understood in relation to machining theory. This work focused on understanding the separate effects of chisel and cutting edges during UAD in comparison with conventional drilling (CD). Experiments were perform...
متن کاملUltrasonic Examination of Fiber Reinforced Plastics Using Phased Array Transducers
This paper presents a data fusion method between the results of ultrasound using phased array at 5MHz frequency and those obtained through eddy current examination at 1-10MH frequency. The obtained results are compared with destructive tests, a very good correlation being obtained. The effects of delamination over the properties of CFRP are studied using dynamic mechanical analyzer, emphasizing...
متن کاملApplication of Ultrasonic Assisted Machining Technique for Glass-Ceramic Milling
In this study, ultrasonic assisted machining (UAM) technique is applied in side-surface milling experiment for glass-ceramic workpiece material. The tungsten carbide cutting-tool with diamond coating is used in conjunction with two kinds of cooling/lubrication mediums such as water-soluble (WS) cutting fluid and minimum quantity lubricant (MQL). Full factorial process parameter combinations on ...
متن کاملSurface Quality of Staggered PCD End Mill in Milling of Carbon Fiber Reinforced Plastics
Machined surface quality determines the reliability, wear resistance and service life of carbon fiber reinforced plastic (CFRP) workpieces. In this work, the formation mechanism of the surface topography and the machining defects of CFRPs are proposed, and the influence of milling parameters and fiber cutting angles on the surface quality of CFRPs is obtained, which can provide a reference for ...
متن کاملEvaluation of the Fiberglass-Reinforced Plastics Interfacial Behavior by using Ultrasonic Wave Propagation Method
In this paper, ultrasonic wave propagation in three phases (3P) of composite materials was investigated. The simulation was conducted by PZFlex analysis code, a time domain finite element program. The reflection and transmission characteristics with different shapes of middle layer between glass fiber and epoxy resin are investigated in order to understand basic ultrasonic behavior of energy di...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2017
ISSN: 2212-8271
DOI: 10.1016/j.procir.2017.03.278