ULTIMATE STRENGTH AND FAILURE MECHANISM OF PC MEMBERS UNDER COMBINED AXIAL TENSILE FORCE AND FLEXURE
نویسندگان
چکیده
منابع مشابه
Ultimate Strength and Failure Mechanism of Resistance Spot Weld Subjected to Tensile, Shear, or Combined Tensile/Shear Loads
Strength tests were performed to reveal the failure mechanisms of spot weld in lap-shear and cross tension test samples. It is shown the while the lap-shear (cross tension) sample is subjected to shear (normal) load at the structural level the failure mechanism at the spot weld is tensile (shear) mode at the materials level. Based on the observed failure mechanism, stress distribution is assume...
متن کاملA unified approach for determining the ultimate strength of RC members subjected to combined axial force, bending, shear and torsion
This paper uses experimental investigation and theoretical derivation to study the unified failure mechanism and ultimate capacity model of reinforced concrete (RC) members under combined axial, bending, shear and torsion loading. Fifteen RC members are tested under different combinations of compressive axial force, bending, shear and torsion using experimental equipment designed by the authors...
متن کاملUltimate tensile strength of tooth structures.
OBJECTIVE This study determined the ultimate tensile strength (UTS) of enamel (E), dentin (D) and dentin-enamel junction (DEJ) using the microtensile technique. It was hypothesized that the UTS of dental structures varies according to location and nature. METHODS Intact occlusal enamel surfaces from extracted human third molars were etched with 37% phosphoric acid and bonded with a one-bottle...
متن کامل"ultimate Strength of Members of Reinforced Concrete Frames in Combined Bending and Torsion
متن کامل
Ultimate strength analysis of composite sections under biaxial bending and axial load
A new generic fiber model algorithm is presented that allows for the efficient analysis of arbitrary composite sections under biaxial bending and axial load. The geometry of the cross section is described by multi-nested curvilinear polygons i.e. closed polygons with edges that are straight lines or circular arcs. The polygons may be convex or concave and may contain openings. The stress–strain...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Doboku Gakkai Ronbunshu
سال: 1995
ISSN: 0289-7806,1882-7187
DOI: 10.2208/jscej.1995.508_55