Transient Creep Mechanism in Pure Aluminum at High-Temperature
نویسندگان
چکیده
منابع مشابه
Pure climb creep mechanism drives flow in Earth’s lower mantle
At high pressure prevailing in the lower mantle, lattice friction opposed to dislocation glide becomes very high, as reported in recent experimental and theoretical studies. We examine the consequences of this high resistance to plastic shear exhibited by ringwoodite and bridgmanite on creep mechanisms under mantle conditions. To evaluate the consequences of this effect, we model dislocation cr...
متن کاملTexture Measurement in Aluminum Alloy at High Temperature
The casting and hot rolling process is a most important and widely used industrial route to produce aluminum alloy sheet[I]. Because rolling is such a high volume process and the capital expenditure in plants and fabrication facilities is so large, even small cost savings or increases in efficiency can result in a very large total money savings[2, 3]. To remove the very costly and time-consumin...
متن کاملOn Nucleation Temperature of Pure Aluminum in Magnetic Fields
Solidification of pure aluminum without and with a magnetic field has been investigated by differential thermal analysis (DTA). DTA curves showed that the nucleation temperature of pure aluminum was decreased as a magnetic field strength increased although its melting process was almost not influenced. The nucleation suppression could be attributed to the increase of the solidliquid interfacial...
متن کاملDuctility of 6XXX aluminum alloys at high temperature
3914)"Graduate Student, Department of Materials Science & Engineering, Faculty of Engineering, Shibaura Institute of Technology (3914 Shibaura, Minato-ku, Tokyo 1088548). 芝浦工業大学大学院生(東京都)〔現在財日本品質保証機構(東京都)〕"Graduate Student, Shibaura Institute of Technology (Minatoku, Tokyo).〔Present: Japan Quality Assurance Organization (Setagaya-ku, Tokyo)〕. 芝浦工業大学工学部(東京都)"Faculty of Engineering, Sh...
متن کاملCreep of aluminum syntactic foams
Aluminum syntactic foams with densities of 1.2–1.5 g/cm3 were deformed at 500 ◦C under constant uniaxial compressive stresses ranging from to 14 MPa. The foam creep behavior is characterized by a short primary stage and a long secondary stage where the strain rate is constant and inimum, followed by a tertiary stage at high stresses. The minimum strain rate varies with stress according to an ap...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Institute of Metals
سال: 1987
ISSN: 0021-4434,2432-4701
DOI: 10.2320/matertrans1960.28.644